Find trusted local electricians in Paddington NSW

Our electric swing gate won’t open, not responding to the clickers

Need a licensed electrician to: Lower the existing power point from its current position on the wall to the new marked location below. Recess the electrical conduit within the outlined area on the ground, ensuring it is properly embedded. Coordinate with the construction team to pour or adjust the concrete slab in the marked area to accommodate the recessed conduit and new power point position. Ensure all work complies with local electrical codes and safety standards.

Disconnect old electric oven and wire in second hand Miele (60cm)

We have two areas in the house where TVs were hung, and we'd like the electrical removed and patched to create a clean wall surface. Both were for small tvs, under 35in.

Medical bed doesn't move with foot pedal

Connect four lighting wires to plugs to enable new Cabinet lights

Replace an existing bathroom light / exhaust with a new one I have purchased, as the existing light flickers from time to time. Install a new Clipsal Saturn light switch with a new one I have bought, as the existing switch seems to jam when pressing the button. Change the lighting configuration of some Clipsal Saturn switches.

Need to upgrade pile point to 15 amp

Construct and fit a wooden box to cover the exposed fuses on the outside of a terrace house Needs a door that opens to get access to fuses

Change 3 pendant lights (dimmable switches) See pics

I am looking for a qualified electrician to complete the following tasks in my home: (see photos attached) Remove and Replace Light Fittings: Remove two old light fittings in the kitchen. Install two new light fittings (I will provide the lights). Install New Light Switches: Install one new light switch in the kitchen. Install one new light switch in the laundry. Separate Control for Laundry Light and Exhaust Fan: Currently, the laundry light and exhaust fan operate together. I want to modify this setup to allow for separate control of the light and fan. Requirements: Must be a licensed electrician with experience in residential electrical work. Preferable date is Wednesday 11th December. Thank you!

-Service and clean 3 split system air conditioning units. -install 2 new GPOs (supplied by me). Wiring already in place to GPO location - Need to connect to mains board. -replace 3 existing single GPO with doubles (supplied by me) - install 1x new Haier split system air conditioning unit on ground level (unit supplied by me)

I need a someone to help fix 1 of my electric recliner bed/chair. It is broken, there was a loud popping sound so I believe something has happened to the wiring. I have attached an image of the chair.

Flat roofing repair and installation of skylight. The current sky light is a bad design and has been leaking. The roof is approximately 4 metres x 4.7 metres. Current skylight is approximately 3800 x285 00 mm

To remove one pair and install a new pair of vintage wooden wall lights or sconces which are already wired and were previously in my other home.

We need an electrician to install the lead from a motorised zip screen into a three point plug which will connect with an outside GPO

Hello, We are needing a fully qualified and insured electrician to hand three new lights. You will be replacing the 3 old light pendants with 3 new ones

Need an electrician or handyman to fix our small lamp. Light is flickering on/off and slight spark in button when turning on/off.

I’m looking to get the following electrical work done at my terrace located in Paddington this week (week commencing 23 September): 1. Front Entry Light – Replace existing light (light supplied). 2. Fan with Light – Replace existing fan and light (supplied). 3. Hallway Light – Replace existing light (supplied). 4. Bathroom Light – Replace existing light (supplied). 5. Doorbell Camera – Aqara G4 is already installed for battery use. I need it hard-wired below the front entry light (supplied). Kitchen Work: • Replace and install 5 GPOs (not supplied) – currently exposed due to kitchen renovation. Throughout the house: • Replace GPO and light switch covers that have turned orange. The details are as follows: • 1 x 3 light switches + 1 dimmer • 3 x 2 light switches (vertical) • 1 x 1 light switch + dimmer • 3 x 1 light switches • 1 x 2 plug GPO (vertical) • 1 x 2 plug GPO (horizontal) Please include: • GPO replacements for the kitchen • GPO and light switch covers for the house Let me know if you need any further details or when you’ll be available to complete the work.

This is a FORTIS 700C electric commuter bike. After one recent short trip (without any previous malfunctions over e3 years) when switching the bike on it showed this error. E08 I had advice perhaps the battery needs disconnecting and reconnecting. It is located within the bike main frame shaft and needs 8 screws undone to remove the battery. Perhaps some other procedure?