Find trusted local electricians in Perth Central

Helping installation of AP

I have a 20kva 3 phase diesel genset that was previously hard-wired into a house, and which unit has been removed from its location. It is a very low hour unit in mint condition. I need to convert this generator into a fully portable unit. This means installing a new switchboard on the generator with 3 phase and single phase outlets. I have a new and unused generator switchboard which is wired for 1 phase. This switchboard already has 4 x 15A 240V single phase outlets and 1 x 20A 240V outlet, and I have a new 40A, 3 phase outlet to bolt to it, to replace the 20A single phase outlet. The new switchboard has a length of 4 wire 3 phase cable coming into it, but only single phase is wired up. I need to convert the switchboard to all 3 phase, and end up with the 4 x 15A 240V single phase outlets left in place, and the 40A, 3 phase outlet added. I would like a price to convert the switchboard to 3 phase. The single phase switchboard has been professionally built, it just needs rewiring to meet Australian Standards for a portable 3 phase genset.

I have a floor lamp that I purchased second hand. It has a halogen light at the top and two led lights, see photo. When I turned the light on, there was some smoke coming from the top light which is the halogen light. I would like it checked and if it’s not electrically sound also fixed so I can keep it.

Electrician needed to fitoff 6 lights.

Shifting of 2 new power points and 1 blank installation, Electrician need to advise list of parts required so I can get from bunnings asap and this is 1 Bed apartment on 10th floor. We require surface wiring with conduit type installation. I will help with parking in building and pay you the labour charges

Home Rheem gas hot water tank hot water pressure low, plenty of sediments in water tank needs maintenance, anode needs to be replaced. Thank you.

I would like to install a solar panel system on my van, it’s a 1983 toyota hiace and already has the plugs but only works in a powered site

We are looking for an electrician to change the existing 65-70 lights to LED. Please come in to have a look and give a quote.

LED aquarium light is not getting full power to one of the colour chanels.

Hi I’m looking someone to take out and put new cable 230V for 3 light in kitchen. Is concrete ceiling so cable need to be pulling out and replace for new one, they are in plastic conduit. Access to cable and transformer from this light is in wall behind so should be easy. Happy to provide more inf Please send me price offer.

Canningvale - connect new range oven - gas and electric required. simple job - slide out old and replace with new oven - connections already there. Also 3 pendant lights to fit to ceiling.

To get my van set up on an off grid set up and get all of the electrics working good. I don’t have any of the parts apart from a battery. I need help ordering everything I need and fitting it.

Need a qualified electrician for oven repair

Electrical repair to industrial oven

I have a patio and need it installed. It is a electric with retractable roof.

1 install dining room light over from current one and remove old 2 fix plug socket in room - I have a replacement plug socket 3 change 2 socket to 4 socket - supply white 4 phone socket on wall remove so I can paint over 5 light switch is behind picture need to put on near by light switch so I can use 6 3 down lights need replacing - white bright - supply and fit

Looking for someone handy with soldering and basic electornic troubleshoot to fix some small stage animatronic style props. Would recommend a hourly rate?

Hi there Currently have an office in West Perth that has a ceiling that I need to do the following works to: 1. Removal of ceiling panels (these just slot out) 2. The grid that holds it is to stay 3. Electrical cables and data cables to be tidied up or removed or taken back to their point of origin 4. Any ventilation pipework to be left or secured if necessary 5. Air vents to be moved if requested You will need an electrical contractors ticket - this is not for the hobby enthusiast. You’ll also need to have a certificate of currency to undertake the work. Will pay a day-rate and an opportunity to do the rest of the office as well (as we get there over time). Would take a day to complete, hence a day rate. Message me with any questions

I need my down lights changed

I need an electrician to install a crystal chandelier