Find trusted local electricians in St Ives NSW

We have a plumbing plan. See attached. Can meet onsite to quote. Also, redirect water outlets from inside to outside.

My roof top solar have been installed flat and I need them to be on an angle, around 34 degrees. There are 24 panels in total. This will require a qualified solar person and the supply of some legs for the panels. The roof is flat and the site has very easy access. I have no idea on price, I'm sure I will find out!

I need an electrician who can fix “Nice” remote for motorised blinds. Link to Nice remote https://www.homeautomationandtubularmotors.com.au/collections/nice-era-p-remotes?srsltid=AfmBOopmc4fkt8lfdCDTGIZbwQJ2QdXt9IWm1BcGwuOE5YgDZM1d_qH2

Smoke alarm to be placed on concrete ceiling of an apartment. Previous form of attachment only temporary and permanent fixing now required. I have the alarm with 2 screws and plugs. Job will require stepladder.

Need to safely remove outside light fitting which was affected by fire. Check safety and replace light. Clean and repaint the surrounding wall. May need to do an initial inspection, provide advice and then source replacement item.

Need to fit a plate on top of wiring in cafe to meet safety requirements

need connection to nbn main cable. then to house etc

I seek an electrician to take care of several general electrical tasks - outdoor power point, tidying up sub-floor cabling (good access), exhaust unit in bathroom and some other tasks. I seek a day rate by way of response. If it takes longer than a day I will extend the terms of the work on this platform to accommodate. The house itself probably needs a rewire, though the meter is new. So follow-on work is highly likely.

Change a fluorescent light and cover or change to a spot light .

Look to get the below list of items installation only:- 1) 25 Downlights (20 outside the house) 2) 1 eye ball sensor (Outside) 3) 1 Flood light with sensor (Outside) 4) 2 Weather proof gpo (Outside) 5) 4 Up and down wall lights from the pillars (2) & next to garage door (2)(Outside) 6) 6 lights on the retaining wall near the driveway 7) Install Led Pool light (tracker to be provided by the electrician) 8) Install smart switch on the front door (Inside) Material will be provided by me so please provide the quote only on the basis of wiring & installation.

Need an electrician to provision cabling along the ground while the turf has yet to be laid to the pool .

Seeking a licensed and insured electrician to undertake various electrical jobs around the house, which include: 1. Replace 8 LED ceiling downights – existing ones are faulty (if you can provide new ones to match existing). 2. Replace 3 ceiling fans (fans supplied) 3. Disconnect 1 ceiling fan 4. Replace 1 bathroom ceiling extractor fan (extractor fan provided) 6. Change 3 light switches/wall socket and install dimmer switch.

Request electrician to remove one old light in laundry and replace with 2x down lights.

I need a technician to service our Bosch Series 4 Heat Pump dryer - it is working well but is making a noise which needs investigation.

Run a conduit wire 5m from a pre-existing power point (outside, along an external wall) to plug into a pre-installed extractor fan (just needs to have power connected)

We have 2 televisions mounted on wall that needs to be un mounted to be moved to another house.

I need one backyard small 1metre high light removed and disconnected from power, one small very simple study room light fixture changed, and a quick trouble shoot of 3 small garden lights low voltage that flicker

Two jobs: 1. Install TV wall mount (we have the wall mount & it just needs to be attached to the wall) 2. Install two battery powered smoke alarms. A bracket needs to be screwed into the ceiling for each smoke alarm

I want someone to connect my Pool Machine and hot water system to the controlled load meter or suggest what is best to do.

While I was cleaning, some cleaning chemical accidentally entered a power point, causing a small flame and tripping the power. I attempted to reset the trip switch at the main switchboard after waiting for five hours, but the issue persists. As a tenant, I am looking for an affordable solution to address this problem. I am considering the following options: 1) Fix the current power point: This would involve ensuring it no longer trips the power, although it would mean the burnt-out power point cannot be used. I am fine with this as I do not use this plug point anymore. 2) Replace the current power point: The goal is to prevent any further tripping after replacement. I have found an affordable option at Bunnings (link provided below), and I am happy to go with this if necessary. Please provide quotes for both options, with a preference for option 2. Here is the link to the power point that I believe you can use and is cheap i.e. 7$ which I found at Bunnings: https://www.bunnings.com.au/deta-double-power-point-single-pack_p4430414.