Find trusted local electricians in Sylvania

Need handyperson or electrician on 1. Install 4 lights (supplied) 2. Fix intercom. The outside intercom only works to open but the people can’t hear our voices. 3. Front gate. Gate lock needs to be reset as it is out of alignment and sometimes won’t close without help.

We have a Haier 9kg Heat Pump Dryer HDHP80AN1. We had someone install it about a year ago and it has never dried properly or takes an eternity, literally 6-7 hours. I thought it was just heat pump systems, however understand it could not be installed properly, not enough power source etc. I want to have it checked by a professional and remedied if possible, otherwise we will change it for a conventional appliance.

RCD is flipping too often inconsistanly for no reason. it is over 20 years old.

Licensed electrician required to replace two existing oyster lights. New lights supplied (not required to be dimmable). RCBO recently installed for lights.

I am after an electrician that can assist with swapping out existing wall switches (old Clipsal slimline) and plugs with the new icon Clipsal. The existing frame in the gyprock walls fits the new switches. Switches are supplied. I also need four pendant lights replaced, existing wiring and pendants supplied. There are 28 Lights switches with varying gangs and 49 Power-Points throughout the house. It also seems that a a number of transformers for the down lights are either loose or out. I’d say there’s a about 6 of these. I would appreciate someone also checking if these can be fixed or need replacing. If you have the knowledge and ability to also check out /reset an Ness Security alarm (no pin or information provided by vendor) that would also be terrific.

Electrolux Dryer Ultimate EDC804BEWA Need drive belt and idler pulley replaced - Due date: Before Saturday, 14 October 2023

I need an electrician to move light fitting 1 metre to the left. I also need 2 GPO (one 15a) and (one neutrik powercon) (I can provide these GPO) installed and the foxtel and aerial outlets from one side of the room to the other. - Due date: Before Saturday, 30 September 2023

I am looking to get 3 internal power points in my single storey house (walls are gyprock). 2 in lounge room, closest existing power point approx. 2 metres away on the same wall. 1 in bedroom next to bed, closest existing power point on other side of the bed . Attached are photos of under house access and switch board. Next few days would be preferable - Due date: Flexible

I have a Pilates studio and I need infrared heap panels attached to the ceiling. I have the panels. They require 230V AC. Let me know if you can help. Thank you. - Due date: Flexible

Electrician to Replace 2 Mains Power Smoke Alarms with new Clipsal Alarms purchased by owner. Photo 1 - existing base to be removed Photo 2 - new Clipsal smoke alarms - Due date: Before Monday, July 17, 2023

NBN cable location needed - Due date: Flexible

1. IXL needs to be installed in main bathroom roof which will require some cutting of the roof also removal of current light fitting. 2. Power point to be installed in roof of garage. 3. New light bar required to be installed on garage roof, currently theres an existing light which needs to be swapped out. Please send license number through. - Due date: 8th June

Our lights have gone out and couldn’t figure out the route of the issue - Due date: Needs to be done on Wednesday, 22 February 2023

Fitting new 5 smart light switches - Due date: Flexible

Intermittent start and head unit does not switch on - Due date: Flexible

I need an electrician to connect a pool heat pump to my Power supply - Due date: Flexible

15amp power point installation

Need someone who can connect the gas and power Also need the right part to connect the gas as shown in the photo

Need an electrician to uninstall and take down an existing Daikin split air conditioner based in an old house that will be demonlisted Monday. Needs to then be reinstalled in another house. - Due date: Before Monday, 9 May 2022

To drill a hole on a single brick wall 3-4 meters high, route a CAT5 cable through the hole to 2nd floor socket board a couple of meters away from the hole (btw brick wall and G-prick board), connect cable to phone socket and install a box to hold the other end of the cable outside the wall.