Find trusted local electricians in Waterloo NSW

Our smoke alarm requires replacement after 10 years.

2 x ceiling fans Run power from existing light switch on wall to ceiling fan to be installed in ceiling in both bedrooms. Straight forward. Power point in bathroom to be installed directly next to existing power point. Needed to power washing machine. Very simple job.

Looking for licenced electrician to remove 3 ceiling lights and install 3 ceiling fans in their place in my apartment. This can be done over several days. Ceiling fans are remote controlled. Ceiling is gyprock. Please see pictures of fans and existing lights attached.

There's no power in the kitchen, but there's power in the bedroom and the living room.The switch will fall if you push it up.

Electrician Needed for Smoke Detector and Downlight Relocation Date: Tuesday 1st October We are looking for an electrician available tomorrow (Tuesday 1st October) to: - Disconnect 3 existing smoke detectors and 1 evacuation speaker from the current ceiling. - Collaborate on a solution for 6 existing downlights, which are not hard-wired. - Assistance is needed to determine the best method for integrating them into the new dropped ceiling. - Reinstall the smoke detectors, speaker, and downlights on the new ceiling, which will be completed by Friday, 1st October. Additional Details: Will need a large A frame ladder to reach the ceiling of 4.2m A team will begin framing the new ceiling at 12 PM on Tuesday, so the electrician will need to disconnect the detectors and speaker prior to this and then remain on-site to assist with positioning the new fittings once the framing begins.

I need help with fixing the lights of 2 bedroom, the switch doesn’t work properly, putting back a globe that has fallen and changing the lights of the living room globe.

Need two pendant lights and two flush mount lights installed.

My Electrolux washer dryer turned on briefly and then went completely blank. it’s only approximately three years old. The PowerPoint is fine. also the dryer has never really worked so would be good to understand what’s going wrong there. Can you please quote visit cost and approximate price if the electrical board needs replacing?

Install a steam generator. Supply and install 1/2" copper water line to generator, Supply and install 1/2" 316L stainless steel steam line and flexible hose from generator to unit in lab, supply 1.off T with a 1/2" full ball 3 piece ball valve and 1/2" BSP - 1" triclover connection, PTFE seal, blanking cap and clamp. Supply and install 1.off 1" BSP tube toe and pipework to run pressure relief valve out side building. Supply and install 1/2 copper line and connect to blow down vessel.

LG air conditioning unit is showing a CH 151 error message

Move 1x existing dimmer and install 3x more dimmers in existing switch house

As discussed, I'll ride the bikes one-by-one to your place. Please enable Afterpay. 1) DRZ400E 2005 ADF: Battery sometimes goes flat when not ridden for a few days (Fine for a night or two. New full Lithium battery) 2) KLX400R 2003: Brake light not working. (New dual filament bulb, running light works fine) 3) SV650S 2002 (EFI): Front indicators only working intermittently

Install x1 plug socket (which has x4 plugs). The wall has existing outlets plugs at the other end - one of which was recently installed with no issues. Based in the Waterloo & there is free parking right outside. Tuesday afternoon from midday or Friday after from 2pm only (as I’m in the office the other days/times)

Need: - existing dishwasher replaced (bought a new one) - existing electric oven replaced (bought a new one, 60cm) All new appliances already delivered to apartment. Just need someone to remove old, install new Can dispose of appliances in basement carpark Time: flexibl, location: Waterloo

Rewire plug on rice cooker. The plug is from Taiwan, plugs into wall using adaptor

The lid on one smoke alarm won’t close properly. Secondly a bedroom sticks when opening & closing, possibly needs slight shaving down. Based in Waterloo. Day / time options; Tues after 11am Fri after 230pm Sat after 12pm Sun after 12pm

Quote: Job#1: - 1x recessed downlight( supply and install ) and 2 gang switch (supply and install ). Wall is made of plasterboard . You will need to drill a hole in wall to make a space for down light and supply and run the cable through the wall internally from exisiting socket or light button to down light spot( see pic ) Job#2 - 1x double powerpoint (supply and install )on benchtop includes cutting the stone to make a space for power point . You will need to supply and run the cable from exisiting power point to new power point spot from behind the wall internally (see pic )

We are a timber flooring showroom in Waterloo in need of a few handyman tasks. Our fee is for labour only. Materials will be provided where necessary. Please be ready with your own tools. 1. Our back wall is made up of timber slats, one of which has come loose. This needs to be glued back and secured. 2. Toilet seat has come loose. Looks like it needs to be screwed and secured 3. 1 x door handle to be screwed into wooden door (door handle provided) 4. An electrician to repair or replace LED strip lighting in multiple areas of the showroom . LED strip lighting to be provided.

Need an electrician to check as the main switch is flicked quite often

The plug for my dryer appears all burnt & seems it nights to be rewired. Dryer seems otherwise fine