Find trusted local electricians in Watsonia North

Check power to electric shutter which doesn’t operate ..when rotating switch to operate shutter all the lights in house goes off ..New haiger power board recently installed

Looking for a registered/qualified electrician to replace a number of light fixtures (see product shots) including: x6 spot/multispots x2 pendants x1 chandelier x1 outdoor wall All are replacing existing lights in the same position, ceiling heights in all rooms are 2500 for reference. [I’m also in need for new powerpoint and aerial sockets, but am happy to discuss this work separately]

I need three Mack RCBO switches replaced. (See photo) They were recalled some years ago. Replacements priced at around $35 each and half an hour's work at most. Only qualified and certified electricians need to apply. Need a certificate for work done.

Need a qualified electrician. Have lost power to half of the house.

4 LIGHT FIXTURES TO BE REPLACED

Cabinet protecting electrical switch board has broken as per photos and needs repair or replacement asap.

Small Kings 2kva generator, the revs fluctuate up and down and runs rough. Has less than 10 hours on it but out of warranty, anyone good with small engines and carbys?

Someone unqualified tried to put a plug on the end of an oven cord that was originally hard wired in the wall cavity. They also placed a power outlet for it, but I’d like the cord replaced properly and the power outlet rewired by a qual’d sparky. Flexible with time Tuesday 😊 - Due date: Needs to be done on Tuesday, 19 December 2023

I have a house and heating is not coming out of ceiling.. can u have a look please

Need 5 fixtures installed. 3 pendants in one room that needs the cords pulled through roof. Existing cords that are capped behind plaster. One fixture in laundry with cord already there. One fixture in hallway with exisiting light fixture. - Due date: Flexible

I have painted my 3 bedroom house and now want to switch out the old original light switches and GPOs so it looks new to match new paint. I have reno's the bathroom and kitchen and already have new points there just in the bedrooms and lounge/common areas that need changing. There are: - 6 x single slim light switches - 1 x double light switch - 5 x DGPO - 3 x single GPO - 2 x aerial points I can purchase the switches and just need the electrician to do the actual change overs and fit back to wall. All points are still electrically attached and not touched, just removed from the wall to assist painting as seen in photos. - Due date: Flexible

2 bedrooms currently have old lights hanging down, these need to be removed and replaced/fitted with downlights I would also like to add sensors to my front and backdoor lights, whilst still able to use the current on/off switches - Due date: Flexible

- Excel list of fittings and switches attached. 28 switches (13 plates) and 16 fittings. - Supply and replace all ex. switches/plates with Clipsal push buttons and wire in Shelly's (supplied by me) behind every switch. - The Shelly 2.5 can control 2x10 Amp / 2.3kW circuits so I'd use 1 Shelly per 2 switches. - Use all existing wiring, except the living ceiling fan and lights to 3 bedroom and 2 bathroom fans. - There's a relatively easy way to wire the living room ceiling fan. Run under the house (2.4m head clearance) > up the wall > along the eaves > up the roof. - See photo's of living and kitchen ceiling attached. - Access into roof for the bedrooms and bathrooms is easy - walk in from the mezzanine or climb up from the laundry. - Due date: Flexible

I need a double outdoor PowerPoint supplied & installed on back of shed for water pump. Existing power inside bungalow directly behind pump location. Would like done asap

We currently have an existing 60cm oven that needs to be disconnected and install a new 60cm electric oven that we purchased. Please note that we will dispose the old oven. We will require an electrical certification of compliance for insurance purposes.