Find trusted local electricians in West Melbourne

Hello, I require an electrician to install 3 chandeliers,to be hard wired on the roof. A few pictures attached, weiging 7kg's- 9 kg for 2 mediums ones and 15kg for the big one. Also, require few other electrical works like converting old style BULB to LED sockets, install heat lamps and install few electrical outlet. Please let me know what all will be required and quote.

9 Additional down lights in 3 rooms, each room already has Switch one down light. Just need to add more down lights. Facade lights ( wiring already available, just installation of lights)

Requesting quotes for following jobs: - Install 4 motion sensors on existing 4 outdoor lights (photos of existing attached. 3 double light and 1 single. Sensor purchased also attached). - Replace 1 existing outdoor light with a motion-sensor floodlight. - Install 3 pendant lights above the kitchen island (3.6m ceiling height, provisions/bulb provided by builder, needs to be replaced). - Install 2 wall-mounted bedside lights (existing provisions).

I am after some electrical installation and handyman service. Electrical - outdoor sensor light and solar pillar light Handyman- few screws in the walls for putting slab* 5/ wall clock/ photo frame and nail wardrobe wood piece that gave way.

1. Remove old and install new 60cm gas cooktop. 2. Remove old and install new 60cm electric rangehood and 3. Remove old and install new 60cm electric oven 4. Dispose of old gas cooktop, old electric rangehood, old electric oven and peripherals. 5. Ensure there are no air gaps between external walls, cooktop, rangehood, and oven - to maintain good insulation for the house. 6. Ensure rangehood vents air from the cooktop to the outside to eliminate food cooking odours inside the house. 7. Ensure rainwater cannot enter through the externally facing rangehood ducts and vents - to maintain good water protection aganist flooding/leakage. 8. Undertake carpentry and repair to cabinetary as needed.

Exhaust fan is not working in the bathroom .

Exhaust fan is not working in the ensuit bathroom.

I’m having a few problems with the electrical system in my 2006 Honda Accord Euro, the main one being that it’s blown 2 sets of brand new Narva headlights in the last year or so, at low RPM the headlights noticeably dip for a moment and if I have climate control running the fan speed dips for a moment. At idle all the interior and exterior lights would visibly flicker, and it was much more noticeable before I replaced the battery recently. Also after not using the car for a couple of days the starter motor struggles to start the car, whereas subsequent starts are not as much of a problem. Would like an auto electrician to diagnose and resolve the problem(s)

I need to add a power point for induction cooktop, install induction cooktop, install canopy Rangehood(duct already done), and replace my hard wired oven with the new pyrolitic oven (also hard wired required)

Need a new outdoor electric plug for an irrigation system

Need someone to remove these pipes and wires. We created a garden bed alongside the house but upon digging, found wires connecting to little lights along the timber. We removed the lights and dug up wiring but have now found that the source connects further (unsure where). Need someone to come and either find the source/ remove, or simply remove the wiring from ground level and put something on the wiring to section off the electrical. Everything you see in the picture is loose, until you get to the pipe leading into the ground. Not sure if I need a plumber or electrician. Thanks!

New GPO - Install new GPO - Supply on opposite side Loose Laundry Mixer - Tighten mixer

Need to put back 2 downlights since I'm renting out this property. I previously had chandeliers in that spot.

Fix these issues highlighted during compliance - Oven gpo requires rcd protection, kitchen gpo won't turn off iconic series,

I would like to fit 2 ceiling fans and install downlights in 2 bedrooms and garage

Remove electrical cable, not sure if there is power running to it.

Seeking a qualified electrician to connect one powerpoint. Powerpoint has two outlets, and one switch (middle) that powers an old window fan. The fan is being removed, and the wires going to the fan needs to be safely disconnected. No need to replace faceplate, happy to reuse existing. 5 minute job for any sparky.

Looking for qualified telecommunications technician to re-wire to new back plate connection with certificate of compliance - previously incorrect wiring. Note: image 2 is previous connection- I could not replicate, used to connect to modem.

Hi I have a google nest smoke alarm ready for installation... just need to connect to the mains.

3 pendant lights and 2 new switches