Find a fence installation professional in East Brisbane

Existing picket fence is rotting and leaning. Total length is 11 meters. Pathway gate needs replacing and driveway gates. Remove old structure, Replace and paint white. Install and supply materials.

Looking at replacing my timber fence and 0.5m of fence at the front to a metal fence that is half pleasing to the eye. We have just moved in to the new house and My dog has been chewing at the gate to get out. A metal gate and fence will eliminate this. Would also like to swing the gate from the other side as the latch rubs on the downpipe when opening.

Fence been made, but need to buy and install 2 sliding gates and a pedestrian gate. Measurements need to be taken of the gate area prior to placing the order for the gates.

hello, I need a builder or a knowledgeable handyman to relocate my timber boundary fence on either side of my property. This is a 2 part job. part 1: There is a wire fence in place indicating the actual boundary of my property, and that needs to be pulled up part 2: move my existing timber fence half a meter back to replace the wire fence my timber fence is about 35m long on either side (both sides need to be moved to replace wire fencing

Need to side access gate made and installed down the left side of our house. One side can be anchored to the timber fence and the other to the brick in the side of the house. The space is 90cm wide. Will need to have limited space underneath it so the dogs cannot get under it. Am open to ideas on style and materials.

Replace approx 6 m fence.

We are installing a new fence. Material all supplied. Need posts installed.

We have wooden fence needs to be replaced. It if someone can install colorbond fencing

Hi. Wanting g a side gate supplied and installed. Timber or steel is fine happy to go with your recommendations. Width is around 920mm wide. Wanted gate 1800 high Thank you.

Install a panel above existing gate.

WE have 2 steel posts that support the deck above that require replacement due to rust which is compromising support

I’m looking for a someone to install a privacy lattice panel on my verandah between two existing support poles. The verandah is easily accessible from all sides. I don't have the lattice panel so would appreciate if you could supply it and add it to the quote. Measures are in the photos and Length is 2610mm. Ideally it would be the same pattern/size and design of the existing panel so they look the same.

To Install fence in the backyard to keep seperate privacy between the granny flat and main house. The fence will be at least 1.8m in height. Roughly along the red line in the 1st photo. Total around 25m to 30m long. Like to have a quote on how much will it cost (material and labor) and how long will it take?

Hi looking for someone to build a colour bond fencing around our house. Need the existing wooden one gone. Only to be done partially so looking at about 10 MTRS plus 2 gates.

Hi Team, seeking a handyman who can build a gate and fence (approx 2m) from the side of the house to the fence to match the timber gate/fence on the other side of the house

1. Remove existing fencing panel (1.89 m x 1.8m H) 2. Install posts for Stratco gate and concrete in 3. Use part of existing fencing panel, gate frame, channels that enclose gate frame, gate latch and gate hinges to create gate. 4. Use balance of existing fencing panel to fill in space between gate and next fencing panel. 5. Take away any spoil or off-cuts All Stratco materials supplied by the Purchaser. Tradesperson to supply rapid set concrete and all tools and equipment. The gate is to hinge off LHS (as you look at photo) near the side fence, and open outwards towards the street.

I need a pvc fence installed across front and up left hand side of driveway. I’ve already purchased the fence however wish to change the gates to 1m wide & may need some extra components. Hedges will be removed and I want fence to sit behind where they currently stand rather than on the retaining wall. I want new fence to run further into the yard than the old timber one, and join to the brick work beside garage rather then the wooden post on my pillar. This will involve a few posts needing to be drilled into the concrete driveway ( 4 in total)

Replace 12m old fence with 1.8m high single paling treated pine timber fence (start asap). Already got neighbour approval and ready to start . Fence building license and insurance required

Need a tradie to measure quote, supply & fit 2 black aluminium driveway gates I need them replaced asap

I need my old clothesline reinstalled into my backyard. May need a post to be added to the base? Happy for you to come and assess before giving me a quote?