Find a fence installation professional in Paddington QLD

4 x fence posts to remove 6 x new posts to install Please supply the posts + materials 4 posts need to be tall for the purpose of building an arbor The existing posts measure around 1500mm tall (+ extra concreted in the ground) x 75mm deep x 100mm wide The 4 new tall posts need to be at least 2200mm tall (+ extra concreted in the ground), but will take your advice on height.

Supply and install privacy screen on two sections of the fence to create privacy between neighbours - Due date: Flexible

Existing timber gate approx 900 wide. Install with side post Existing gate provided- relocation of existing gate. Due date: Flexible

To construct a 2.5 wide fence with gate on an external deck to close off a backyard to allow dogs to be kept in. I can purchase all materials needed bu am looking for a carpenter to undertake job. - Due date: Needs to be done on Monday, 31 July 2023

Needing a standard timber gate made and added onto a pre existing fence - Due date: Before Sunday, 29 January 2023

We want to have a timber gate across a pathway about one metre wide to fit into existing timber posts on either side. The gate to be built from timber slats matching the fence, painted to match, fitted with a gate latch. Please see a photo of the pathway and fence, but you would need to visit to check measurements, fixtures, and timber requirements for the slats and frame. - Due date: Flexible

Hello! I need a double gate Approx 3.5/4 mt to be installed in an existing fence. - Due date: Flexible

Removing old steel fence and build new one. All wood is ready to go .

I need a quote to replace a timber fence. The fence is a corner section - 2.3 X 4.1 2m high This job requires the replacement of HWD posts rails and palings.

We have a small Queenslander and want to install lattice on the front verandah. 3 panels are required. - Due date: Flexible

I need another set of hands to assist in installation of prepared fence materials for a trellis. I have purchased 6 x metal fence post, have drilled holes for wire cables. The posts need to be attached to existing wooden fence posts and the wire needs to be threaded and tensioned. Estimate that the two of us could knock the job over in 3 hours as all the metal posts are prepared and just need to be installed.

There is a gap between our boundary fence and garage. We will provide all material but need someone who has a decent knowledge of how to fill such a gap with a metal flyscreen sheeting.