Find a fence installation professional in Sunshine Coast

Install a 3.6m gate onto existing timber posts. All hardware provided. The bolts require cutting to size and need to go all the way through the post.

Build a wooden fence with chicken wire around chicken coup approx 10x 12 meters with small gate for access.

Need 3 post fences installed. Have concrete and the posts so all that needs to be done is them installed

Hi, we would like a side fence with a gate built. It measures 3.5m long, 1.8m high. We are looking at using the 8cm wide battens but close together for privacy fencing. We can purchase the deco batten materials we would like someone to make the frame for it and install it. Please let me know a price and timeframe of when you can do this please.

Looking for handy person/builder who can build two gate. 1. One pool gate - existing one in photo. Needs to remove gate, can use the same steel base (will need to repaint) and add wooden timber as shown in fence. 2. Rear gate of property - will need to make a brand new gate and attach to fence. Similar To picture shown (note, black panel is just holding it together) Need asap. Thanks so much Happy to pay for materials /timber/paint/ brackets etc with proof of receipt. Open to offers

supply and install aluminium slat sliding gate (3m x 1.5m high) for carport. 65mm aluminium surfmist slats with 5mm spacing

We would like the old fence taken away. We believe the Colourbond fence will need to be place on top of a wooden support base. 10 meters of the fence would be at a much lower level than the rest and would need to be staggered down a slope. Colour we assume will be monument. But we will need colour samples.

Supply all labour and materials to: a. Remove existing 100x50 treated pine at the top of retaining wall and replace with new timber. b. Install two vertical treated pine braces at the back of each panel of fence with 100x75mm sleepers bolted in for strength. c. Re bolt fence posts to the retaining wall

Existing mesh metal fence. 3 posts rusted out. Need 3 new posts installed, dyna bolted to concrete. Reinstall panels. I have the new posts already onsite with caps, brackets etc will need to supply 12 x 10mm dynabolts.

Removal/cut out the steel support insert acrow prop then replace with a post attached to a saddle (hardwood post supplied).

Build a timber fence. 32m long. 8 sections. Same timber as in pic. Can supply timber. Steepish land.

Require latch to be replaced on side gate

Need a side gate installed ASAP, picture below shows the area, material - wood or PVC only please House is located in Nirimba QLD PRICE NEGOTIATION-ABLE Measurement from wall to fence is 2m

Installation of 5.5m x 8.5m x 3.6m ht flat steel carport . 4 x 75ml steel posts with plates need to have footings dug to support posts. All materials on site including concrete pre mix bags. photos of location and sketch can be sent

Replace 65 Metres of PVC Coated Chain Wire at rear of Property. All Materials supplied.

Replace rotten timber on side of house

Needing 2x shade cloth pergolas/shelters built down each side of our house, to provide shade for animals. Require pergolas to run from eaves to side fences, similar to picture below. One side approx 4m long and other side around 5m long.

Hi there, Anyone is qualified to help me to build and install the timber garden fence at my cafe. You would need to measure the area.

Install 6m of supplied island thatch white PVC fencing and a pedestrian gate

Build a 9m long timber fence. Materials supplied. 5 posts. 3 rails 110 pails. In Montville. Work must be done between 10am - 3pm any day.