Find a fence installation professional in West Brisbane

Install 10 bamboo panels for fencing

Fence leaning due to one post rotten at the bottom. Needs replacing.

Hi, we require the supply & installation of a 14m long, 2m high colorbond fence; no gates. Plus repair of existing timber fence; replace 30-35 broken, weathered palings.

I’m looking for someone to install pigeon-proofing mesh or netting around my solar panels at my home in Keperra. I’ve had a pigeon problem with them nesting under the panels, and I need a reliable solution to keep them out for good. Perimeter estimated at ~54m (based on satellite imagery). What I need: - Supply and install high-quality pigeon-proofing mesh or netting around my solar panels. - Ensure the work is safe and complies with height safety standards (e.g., certified harnesses, anchors, etc.). - Ideally, provide a warranty on the materials/workmanship (10 years preferred). - Clean up any existing pigeon mess if possible (bonus, not required). Requirements: - Experience with solar panel pigeon proofing or similar installations. - Own tools and safety equipment (certified gear preferred – e.g., harnesses, fall arrest systems). - Insurance and/or police check preferred (please mention if you have these). - Ability to work at heights safely.

I need a timber side gate 1.8m high by approx 1.2m wide with metal frame- supplied and installed on a new build home in Graceville.

Please provide budget for relining of a concrete pool and replacement of coping. $5 is obviously not the budget but the app needs a figure to post the task.

Repair a 6-meter section of the existing fence by removing the damaged post (including attached paling, rails, and the existing concrete post foundation), re-casting the post hole, and installing new metal posts. Additionally, provide and install new hardwood railing and palings along the affected section, followed by a complete work area cleanup. Phrase one: Builder removes the existing damaged fence, owner runs some cleanup to remove the nearby greens, Phrase two: concrete and metal posts in (3 bags of concrete per post), Phrase three: install rail and paling.

Looking to replace a 24m timber fence. The existing fence is still in place and needs removal and disposal. I’d like the new fence to match the attached reference. Please provide quotes and availability. Thanks.

I have a gate that needs a full installation. Will need to be automated. The driveway is level and we have a power point outside of the house. Only contact me if you are experienced in gate installation. Photo of the driveway and the actual gate.

Panels from soffit are being removed on the 21st by somebody else. I just need somebody to replace fibro. No painting necessary. A little prepping may need to be done. Roughly 35 linear meters (600mm panels). Highest point is 4m and lowest point is 2m. Is not a 1 person job as some positions will be ladder access only, but mostly horse and tress.

Pool gate not closing might need replacement

I want to replace old rotting timber balustrades on my deck with steel fencing available typically at bunnings

Several wooden planks of he deck and fence have rotted because of rain. Need to repair the deck and wooden fence that surrounds the deck. The front and back deck needs to be varnished again after several rotten planks have been replaced. A new outside door is to be installed in the garage. In one of the yards the fence abutting the street needs to be replaced with a new fence, probably a metal fence that is rust free?

Build a fence in front of house modern outlook with a solar gate or a motorised roller door for the car port area. Potentially build in a letter box

Need to install side gate about 5m long

I need 6-7 new posts to support these 3 large lattice panels. They were supported by a wooden fence which has now been removed by the neighbours. The posts should be approximately 2.1m-2.6m tall (the land slopes a little bit) so they can support the lattice at both the top and bottom of the panels. The total size of the lattice panels is approximately 6.5m x 1.1m The lattice starts at approximately 1.3m above ground, and the top of the lattice is approximately 2.1m-2.6m above ground. A colourbond fence is planned to be installed by the neighbours sometime between Xmas and New Years so it would be ideal to do this job asap before the new fence is up for easier access.

Fence or barrier to build. Material s and installation is required. The barrier fence will need to be from the ground all the way top of the staircase to hide the pool pump. area. Any suggestions is welcome. The length is 1.75m and the height is 2.3m

We currently have an aluminium pool fence and want part of it changed to glass panels with a gate. The panels will need to be custom made though as they will need to have angles. Unless you can suggest us a better way of doing it.

Fence or barrier to build. Material s and installation is required. The barrier fence will need to be from the ground all the way top of the staircase to hide the pool pump. area. Any suggestions is welcome. The length is 1.75m and the height is 2.3m

Our fence needs replacing with a new treated pine fence. We will remove the old fence (pictured) prior. New fence: 1.8m tall Length is 40.5m Thank you!