Find a fence installation professional in West Melbourne

Install a fence in front of the house with a manual gate that can be locked if needed from inside. I would also want a see through the gate upper part. Suggest me what can i do and we fix up the job

Seeking a skilled professional or team to undertake the following tasks: 1. Removal of Colorbond Fence: Safely remove the existing Colorbond fence. 2. Installation of Picket Fence: Install a new picket fence in place of the old Colorbond fence. 3. Levelling of Brick Mailbox: Ensure the brick mailbox is properly leveled and secure.

1)Build on top of an existing brick fence with decretive breezeblock (supplied) and attach a wrought iron gate. would like the existing brick rendered 2)Also cut concreate to make a flower bed on one half of the driveway. 3) Build a brick wall with decretive breeze block (supplied) and attach a wrought iron gate to separate the front driveway from the back of the house

Install colorbond fence beware 2 garage walls very little space

Hills 6 line Post Installation required - Person should bring all material required for post installation on Concrete

Both fences are completely shot need them replaced please

Supply and install of galvanized steel posts. We need 40 steel galvanized posts with dimension 50mm x 50mm and 2.6m high. Post hole should be 600mm deep and steel posts will be buried and cemented on the ground. The height of post from above ground will be 2 meters, same height as the existing colourbond fence. Steel posts will be 900mm apart. Thank you.

Rear Fence : remove and throw away Supply and install new treated pine fence at 1.8 high approx 16 meters

I've approximately 19m wooden fence and I need it replaced with Colorbond. Can I please get the quotes for 1.8m and 2m pls

Build fence plus gate. One side 3m x 1.8m high. Small side 1.25 x 1.8 high. Plus a 0.92 x 1.8m gate. St Albans VIC Removal of existing 1.5m high fence.

Want to replace the existing colorbond side/garden gate which is coming off the hinges and broken with a new colorbond sheet gate, size 105x170mm. A couple of colorbond sheets are available that be used for the purpose. Maybe the exisiting frame can be reused Scope includes gate prep and gate installation including bolting on the walls.

I have an existing metal side gate that needs to be taken down, then a new gate to be purchased and installed

Build a front side fence, length approx 6.5m. Should be capped timber but open to suggestions. My lot is higher than the neighbors. Fence height should be max as permitted by Council but I understand it needs to slope at the street end? Need fence built asap.

Need this 11 meter long fence by 1.9 m high replaced as wind has damaged. It needed reposted also to similar design as what was before.

Tasker to supply and install side fence gate Color bond gate (white color)

I need a timber wedge fixed to my existing fence to make the fence a non climbable zone . Approx 20 m .

I am looking at installing colorbond fencing in rivergum/wilderness green. Approximately 6.7m wide and 11m long Would also like to install double gates or a motorised sliding gate, still unsure of which at the front and would like the highest fence possible On-site quote would be preferred