Find experienced local fencing contractors in Highgate Hill

I need timber rails installed on metal posts

Aprox 23 meters colorbond fence in back yard at highgate hill , can’t fit a digging machine so post holes need dug by hand

Re-nail some loose timber fence palings and check rest of fence approx 10 metres

Looking for quotes to: 1) remove wooden back fence and replace with new wooden fence 2) 1 x side metal fence removed and wooden fence added New wooden fence to be 1.8m high Land is approx 10m wide by 40m long

I am about to start a renovation and would like an engineer to inspect the boundary fence to complete a report. Report needs to cover current condition of the fence and any current issues. The fence was built by a neighbour. Plot is 405sqm and 10m wide x 40m long. The fence runs along one side of the plot for approx 10m - Due date: Before Thursday, 7 March 2024

Looking for someone (with fencing experience) to quote on: 1. Replacing a 50 metre long timber fence (180cm high on a 20cm sleeper. Steel posts. 2. Replacing the posts on another fence with steel posts. Require all material and installation. - Due date: Before Friday, 9 February 2024

Hi there, we would like a gate built to keep our dogs in a section of yard. It would need to be 6ft and unable to be pushed open. Narrow space to work with, please see photos! You can see where the white (ineffective!) barrier is- that is where the gate needs to be. We think it would need to swing inwards but open to any solutions. We don’t mind if the gate is upcycled , eg. you may have a gate you think you can adapt for the space that’s fine. The measurements are 153cm across and height as mentioned. Thanks! - Due date: Flexible

Remove current fence and install new timber fence. Fence is around 2m long - Due date: Flexible

We have had a screw break/come out of a fence pailing in the privacy screen in our courtyard. The pailing needs to be screwed back in. It is ~4m high so a ladder is needed. See attached photo.

I have two gate posts to be cemented Into the ground and attached to existing fence. And a lock affixed to the entrance gate. A few palings nailed to fence also. .

Existing timber paling fence has been re-screwed on top cross-beam but needs to be nail gunned on bottom crossbeam. 2 nails per paling. Palings are 2cms deep and cross-beam is 4 cms deep.

Construction, installation and painting of two side gates- one is approx .99 wide x 1.6 high and the other is 1.3 x1.8. To match timber pailing fences.

Construct and paint two timber pailing gates to match high fence.