Find experienced local fencing contractors in Inner South Melbourne

Demolition of the fence will be done by us. Removal of green waste by us. Scope of works will be to install 16.0 meters of fence 1.8 meters high. Allow for supply and install for a standard timber residential property. Allow for 8 posts. No rubbish removal.

Supply and install a side fence 40m treated pine timber fence along right side boundary 1.8m high with tapered finish to match the other side. Materials: 1. Hardwood Posts set 65cm into ground and set in concrete 2.Treated pine palings ,plinth and rails. 3.Galvanized nails and batten screws Easy to access as neighbour side vacant at the moment.

remove existing broken pailing and 2nd wider pailing (to close gap) and supply and install with new treated pine pailing and galvanised nails. height approx 110mm (cut on site to correct heights);

Our wooden side gate jams and difficult to open. It has a metal latch. We think hinges need to be tightened or replaced. Please send quotes.

Long wooden fence along lane way may need replacement or at least a lot of straightening and reinforcement

I'm looking for a new colorbond fence to replace existing timber fence. It's separated into 2 sections, one is 17.5m length and 2m height (there's a fall around 65cm over 17.5m length) and the other is around 5.2m length and 2.2~2.3m height. It's on the same boundary line and separated by a small brick wall. If using sleeper on the bottom, I would like concrete sleeper. There's a height difference of less than 10cm between the two property. Please quote me the cost/meter including removal and disposal of old timber fence.

Remove and replace existing fence 3.8 galvanised posts. 11.8m long Neighbours side- traditional pailing fence. Circa 1.8m high. My side (upper side) - cement sheet circa 2m above pool. Pool is above ground. Remove existing

Build a gate into the garden fence. Must blend in with the original fence. Must be strong. Must have a lock. Please can I see examples of work you have already done. Thankyou.

Scope of works : 1. Remove 8.6m of weathered / broken paling fence (see picture), and dispose. 2. Build a new standard 3.2m paling fence from end of brick post to start of brick garage wall (see picture); Height of 1.5m. Use treated pine. 3. Airtasker to supply all materials, labour and equipment. 4. Quote to include all charges, incl Airtasker fees, etc.

I need my glass pool gate adjusted so it closes properly.

I would like someone to please install/affix a net to the top of my fence to stop basketballs entering our neighbours yard. I have netting & some materials to assist.

I have purchased an auto rewind hose reel and need it installed on my fence. A very simple job, just requires 4 holes to be drilled into my paling fence (post at rear of fence) and then screws installed to hold the hose reel. A 5 minute job.

Needing replacement of missing portion of fencing between gate and fence. Any materials/construction fine but suitable for a dog.

My pool fence locking mechanism has come loose from the glass. I need someone to help reinstate it.

Hi, I need a dog fence installed today. If anyone is available, please let me know.

Install fenstar gate. One post concreted in ground other attached to side of house. Main part of gate already but together

I need some repairs done to a leaning timber paling fence in our front garden. The section is about 5-6 meters long and I am looking to have 3 new fence posts cemented in (2 or 3 bags per post) in between the existing posts. Existing posts are 125mmx75mm so looking for same dimensions. Soil is quite sandy and easy to dig. Please quote for labour and materials.

Scope: 1. Existing timber paling fence 2. Straighten 2 small fence sections / posts (4-5m section small lean) 3. Supply and install fixed cost price offer only - Cheapest / easiest option Ideas only: - Install 1-2 posts on other side and push screw fence - Footings install if needed Open to other ideas Easy access both sides of fence

Hey guys, Our pool fence gate has dropped and no longer aligns with the lock. We need the gate adjusted so that it locks again. See images attached

I need my new timber pailing fence painted . Length is 17ms. Height is a standard 1.8ms. I only need my side of ten fence done (not my neighbours side) There are a few plants and trees in the way so spraying it will probably be the easiest way to do this