Find experienced local fencing contractors in Mount Barker SA

I need a Stratco gate installed. Have all the parts, gate and steel poles. It’s about 800 mm wide, and needs the pole bolted to concrete and then the gate latch on the brick wall on the other side. Or, could go in reverse: gate attached to the brick wall and the latch on the steel pole near the fence. No time waste is please, need someone qualified.

About 150m of rural fencing to be installed and 4 gates.

Approx. 30 m of Colorbond fence. Nothing in front of the fence and it's a new build so perfect condition. Need it to be painted Monument.

Fix / replace hinges of side garden colorbond gate (destroyed by strong winds) and reattach the gate. Replace gate latch with a new one similar to the old one. Images are uploaded here.

Build an 1.8 metre good neighbor fence in stratco supadek 18 metre long in slate grey panels and frame No digging required, as it can bolt straight on top of the retaining wall mounting plates, just screw it together. Quote for material and labour.

I require the installation of a wooden gate (width 900mm). I have the gate, but I do not yet have the gate hardware (incl. gate frame)

I need 500mm extensions onto my existing 1500mm high colorbond fence and gate. The length of fence needing extensions is 17500mm. I also need my gate to be resheeted at 2000mm. The colour of our fence is paperbark. I only want the fence to be extended, not fully replaced. Thanks! - Due date: Flexible

Hi, Looking to get 22m of Good neighbour or post and rail fence installed. Ground is pretty even the whole way with the exception of the rear where 4 under fence plinths @200mm high need to put in. Located in Mt Barker, easy access for job. FYI It’s the old steel fence pictured (plus small section where colourbond is) up to the double gates. 22m in total. - Due date: Flexible

I need assistance to complete the install of a dog safe fence, attaching the wires up high and attaching to the house - Due date: Flexible

We need two side gates supplied and installed in Mount Barker. 1800mm tall, Woodland grey to match our good neighbour fencing. One approx 1100mm wide, between a brick wall and a fence, the other approx 1010mm wide between two brick walls . Thanks. First two pics show the areas we're looking to have the gates installed. Third pic is the style of gate we're looking for. Thanks. - Due date: Flexible

I have a few fence panels that need to be installed. They are on the side of the house, in the front yard. They taper down to the front fence level. I have the panels in the yard and a couple of the posts are already in. Will post a photo

Hoping to have a 1-1.2m front fence installed. Preferrably picket however depends on cost. Will do with something simpler (posts and wire, like a balustrate) if needed. Need to do this prior to the sale of the home, so within the next month. Width of the block is 27m, expect fence to be around 21m. No gates.

I am looking some one can repair swings gate, gate need nice look. Steel frame is good, need to change look

Need to have a 1200mm wide glass pool fence panel replaced. The panel has been set into mortar on a concrete plinth. To install new panel you will need to cut the old mortar joint to clean out base of old panel and make good for new installation.

We need two runs of Good Neighbour fencing at our new house in Mount Barker. Both approx 18m, 36m total. One side requires a concrete plinth under fence, the other needs to go on top of existing short concrete sleeper retaining wall.