Find experienced local fencing contractors in Mount Eliza

Slanting fence in need of repair. Definitely 4-6 new posts, perhaps more. You can access from both sides of fence.

Looking for quotes to install timber acoustic panels from Bunnings onto internal wall. Wall is 4.1m long x 2.3m high. Panels will need to be cut from 2.7m high to suit. Roughly 7 panels in total required. Can provide wall panels and screws required for install.

Cladding on chimney needs repairing and some timber battons on a metal gate frame. Have the timber battons but will need to supply products for chimney repair.

8 sections of pool fencing stake to ground removal. Very easy

Glass pool gate is not closing properly due to wooden deck swelling underneath. Requires slight adjustment to bring the gate and the close back together. The pool fence company fixed it last year in 2 minutes but they’re too busy to come round at the moment. Urgently need it done before 27 Jan.

Install 2 metre long x 1.2 metre high aluminium fence and gate. (2 pieces). Custom made by "Mready fencing" for position. 3 posts and fittings supplied. Posts attach to existing structure. No holes or concrete required. Estimated 3 hours work. Looking to pay around $200. Happy for someone to do this arvo or anytime tomorrow or Friday. Must have experience with installing aluminium fences.

Looking for an experienced fence painter to paint about 20 metres of 2.1 metre high existing paling fence. Fence has been up for about 4 years and is still in very good condition. Only need one side painted from ground up to capping (incl front edge of capping). Spray equipment (you provide) is acceptable as long as overspray is contained. Cost is labour only. We will supply fence paint.

Need quotes for boundary fencing. Looking to start asap Front fence - timber picket 30m approx Side and rear paling fence - 200m approx Retaining wall rear - 10m approx

I require 3 columns to be built 600m by 2200mm to support driveway gates. Materials used can be flexible but must be strong enough to support the weight of the gates. Main driveway gates are both 1800mm x 2000mm and passanger gate is 900mm x 2000mm

Fix cut wire to solar panel and set solar controller to get gate automatic gate working again.

Fence brought down with high winds. Just one panel down and needs to be put back in place. May need to replace the 2 post holding the fence in place. I have a photo if required.

Looking for someone to replace fence support posts and reinforce / straighten fence. Repair fence by removing supports you can see in picture. Fence itself to stay same just need new support posts.

Remove old and replace with new 36m X 1.8m high paling fence Concrete in posts

I need a dog proof fence erected. 30 metres approximately. 1500 high. Suggestions would be: Welded Steel Mesh - 1.2m with Steel Star Pickets - Y-Posts. Must be secured where small dogs can not crawl under.

We have a leaning fence that needs to braced until it's replace. can be secured any way from one side

I have all required glass panels, spigots and dynabolts for concrete install.

Looking for someone to install a Post and wire boundary fence and provide all materials and tools for the job. Roughly 30 m in length

See attached image - 2 posts need to be concreted into the ground, 2 posts mounted onto posts as shown. We have all posts and netting here ready to go.

PAILING FENCE NEEDS REPAIRS. WE WISH TO RETAIN THE EXISTING FENCE IF POSSIBLE

Continue paling fence on 2 sides of driveway to close the gap to the front stone fence 1st gap 1300h x 250w 2nd gap 1300h x 400w (to cover exposed block work) No painting required