Find experienced local fencing contractors in Munno Para

Need to remove the remaining of the damaged fence in my property. Need it removed (not cut) so that the new one can be done. You just need to get it pulled out, so that the new one can be installed.

Car was driven through the garage gate, and the sheet on the right side need to be repaired. The frame, lock, and bolt on the damaged one could still be used but we can always qoates around new materials. I’m open to negotiating with the right person, so I’m flexible with the amount I put on here.

Require a Steel Y Post Fence to be installed along front of vacant block of land boundary line. -Pickup 10 pack steel Y posts and wire from Bunnings -Hammer in the posts even distance apart (6 foot) -Ensure that the entire front of the property is fenced off to prevent access and dumping of rubbish -Hammer in the posts into the ground 1 foot -Run three 3 x wires per post across front of property ensuring correct wire tension and twisted to secure

I need 4-5 fence posts and bottom railing supplied and repkaced at an approx distance of 10 metres with the current colour bond sheets put back on as these are relatively new. The damaged posts sit next to a garden bed that has been cleared somewhat and will be looking for someone to dig that out for me too

2 piece of timber 35x140x500 need to be added 2 X 20x35x700 need added Quad 1500 Eave jointer 600mm Paint timber paperbark Please supply material and I will reimburse it

My investment property has got fence that has gaps at the bottom on all sides of rear fence. This is colourbond good neighbour style. This is allowing pests to access yard so if someone could block the gap up permanently as my tenant has temporarily tried. Thanks!

need to repair the fence and the side gate. Gate: The new side gate was installed last year, but it's not strong. I need it to be made stronger. Exiting post are bolted on concrete but i want them to go grond and concrete. Fence: I need to add two and a half plinths to the existing plinths.

Fence recently broken at the base, due to high winds. Please price to reinstall fence post in concrete, or weld to base.

Need front fence design and install across 23m frontage with vehicle access gates (will discuss further requirements later) Minimum 1.6m height but up to 1.8m depending on style and security. Happy to oil and stain ourselves if this can be done in timber but open to discussing steel/timber look slat options as well. Budget conscious and happy to take on some work where possible. Safety and security cannot be compromised and is top of our requirements. Examples and current frontage should be attached

Aggregate for driveway and front of house footpaths. Two side footpaths, rear and alfresco needed too. New build. Fencing with plinths will be in place.

Our Electric Gate out the front can be pulled back a meter without pushing the button to open it

1. Remove the root 2. Remove broken concrete 3. Reinstate the fence. See the photos. - Due date: Flexible

Hi I'm looking for someone who can build a fence around my front yard any help appreciated

Quote for fencing required.

looking for someone who can repair an existing site gate or build a new one. The side gate was built last year and is still relatively new. However, the installer did not do a proper job, resulting in its lack of strength so i want to reinforce and strengthen the existing gate or construct a new one. - Due date: Before Sunday, 26 November 2023

Colorbond fence near pool needs to be earthed. - Due date: Before Tuesday, November 28, 2023

Top put on pergola already established. Screening on fencing block out neighbours - Due date: Flexible

Hi I am looking to put barbed wire fencing as in the picture to colorbond backyard fence Width approx. 5 mtr 3 rows barbed wire with circle Quote Option 1 Material + labour Option 2 labour only - Due date: Flexible

Side fence needs lifting into position and screwing up 2 metres - Due date: Needs to be done on Friday, 8 September 2023

Wind blew down an extension to my fence 2 metres in length needs screwing back up - Due date: Needs to be done on Friday, 8 September 2023