Find experienced local fencing contractors in North Brisbane

Fence off a carport along the edges of the cement. Fence to match the existing front gate shown. Approx 7m for section 1 and 2m for section 2. Please provide a quote.

Replace an old wood fence with a colorbond one, swap screens to metal ones

Hi all! We have an existing 30m fence in place, that is both timber and steel. Please quote with removal of all that is there (and depending on how long it would take, likely a temporary fence over nights). We want a timber fence, 2.1m, capped and NOT lapped There is currently a garden bed along where our property border actually is, and we want fence moved back as far as possible (in line with fence in 4th photo) Please feel free to come to Aspley to quote first if need be

Scope 1. Details • Location: Deagon QLD • Clients: Yuri and Des • Timeline: Flexible - January or February 2025 2. Scope Details • Come to site and refine preliminary quote (if required). • Clear vegetation (optional, if service can be provided, please provide quote). • Remove and dispose the existing fence (mandatory). • Install new fence (mandatory). • Apply protective coatings (if required). • Clean up the site and remove all debris (mandatory). 3. Materials and Specifications • Fence Type: Preference for treated Timber (provide other option if constrained). • Height: 1.8 meters. • Length: approx. 22m. 4. Our Responsibility • Provide access to the property. • Communicate any specific preferences. • Approve design and material choices before work begins. PS: I'm placing 5$ to kick off conversation, please provide indicative quote for this job.

Existing side gate (metal frame with wooden palings) has a gap at the bottom to allow it to swing open (slightly sloping land). Unfortunately little dog can squeeze underneath and get out (I have just discovered). Need to dog proof it.

Need a fence taken down 25 meters on wach side and a new coulor bond fence erected and build two fences, I'm flexible with the pricing aswell.

Hello, my wooden fence is leaning into my yard. At least 3 posts have failed on the neighbours side of the fence. There is no access from the neighbours side, so I would like the fence braced and straightened back to plumb, with 4 hardwood posts installed on my side to minimise disruption. The fence is approximately 1.9m high, with approximately 850mm of garden bed between the fence and concrete. The garden bed does have some small shrubs, but there’s plenty of space between them to work with. Any questions, please ask. I left out quite a bit of useful information in the first edit, so may have missed something else! Thanks for reading!

I need 4 steel sleeper posts installed for a timber sleeper garden wall. I’ve already dug holes to 450mm deep by these will need to be 600mm deep. Posts will be 1200mm high I don’t have the right spade to dig deeper. Ideally, whoever does this will have a laser level or some way to ensure the posts are installed at the right height. I will supply posts and premix concrete. Just need someone’s skill to put the posts in correctly. I wouldn’t expect this to take more than 2 hours for someone with the right tools and experience.

Build fence to extend height of current fence. Fence panels supplied. Need to put up approx 6m of fencing in the corner of pool yard.

Need a colon one fencing done at my new place. Landscaper has already set up the surface and marked it. I need it to be done ASAP

Installing gate inserts into rendered fence. We have brackets but would need screws supplied Previously experience required

Need a fence quote - to replace the existing 35m fence along the retaining wall with a Colorbond and add approximately 5m of Colorbond with a new retaining wall,

Remove old letterbox and install new one into timber fence. Fence will need to be cut. Need done in the morning if possible.

Remove 11.2 meters of rotten over grown fence. 7 m of wooden fence. 8 brick pillars. Then dig the 11.2 m to 40cm deep and 1m wide to remove old roots so new fence and hedge can be installed.

Remove newel posts from the attached brackets & cut brackets flush to ground level and the remainder rust treated. Cut newel posts at both ends to remove any rot, and primed. The handrails & rebated rails to be cut back to remove the worst of the rot & sealed. The galvanised brackets to be reinstalled , affixed to the concrete pad. The posts to be affixed to the handrail & rebated rails & bolted to the brackets using existing bolts. All fixings to be galvanised.

Refer to photo. Small section of fence hit by skip truck. Requires repair.

add palings to bottom of the fence, reason is to stop weeds coming in next door to our yard. front has been done. Wont take you long, need to bring nail gun, saw and you pick up treated pine palings in total 28 palings collect from a bunnings store. Permission is allowed in neigbours yard. Images are where it has been done and an image of where it needs to be done, this is not the full length I have just shown images of where it has to be done. 28 Palings is enough Next job is build a wooden gate to bottom stair, 900height 945 wide approx, something like in this image I will stain if needed. Black Hinges and Black latch for gate you will need to get from Bunnings

Gate kit install on timber fence Will need someone with some wood cutting tools/skills. Have timber and gate hardware already

Hardscape and fencing to support pool install and outdoor bbq area.

House block with side fence from the house that extends to the side boundary. I need someone to Demo existing timber fence (approx 4m)and build a Replacement fence to be of timber paling or colourbond whichever is more efficient. The fence must have a pedestrian gate that forms part of the fence between the house and the boundary fence. Current gate has a steel frame in good condition and may be reused but I think it’s too heavy (potentially needs hanging from the house not a post).