Find experienced local fencing contractors in SA

To supply and install around 40m of chain wire fencing

We need good neighbour fence installed, we’re on a low budget, please message me for more information. 22 linear meters in total 1.8m high Under fence plinth Nothing supplied by us

I need handy man to help me to put a second gate to my fence.

Replace 4 veranda posts. I’ve already purchased and painted the posts, I just need 4 posts removed and then replaced with the new ones.

Need 2 fence sheet panels replaced damaged by gardener $200 plus materials

Updated, apologies had incorrect budget.. Wooden fence and gate are not aligning making opening/closing a constant problem. need to work out if its the post or gate that need realigning and fix

Looking to get a quote for the following: - rendered block or brick fence in white - black tubular aluminium infills - single pedestrian entrance, black tubular aluminium - sliding gate, black tubular aluminium Please see photo for rough design and measurements. If you can only do the fence but not the gate then please specify.

Need a small fence removed . Mostly attached by bolts but 1 post will need to be cut off

Our existing swing gates have started to sag and scrape along the paving of the driveway. Removal of rotting timber gate posts and installation of matt black steel posts (new posts to match existing fence posts along the front fence, 120x120x3mm approx, flat capping on top to match other fence posts). Steel posts to be concreted into the ground. Existing metal swing gates will need removal from the old timber posts, then reattached to new steel posts and adjusted to achieve an even and flushed closure. Existing automatic opening/ closing gate motor will need reattachment to gates to reinstate original function. Please state your licences, ABN and warranties on workmanship and posts supplied. Please supply photos of the new steel posts you intend to install. Thank you.

Need an existing pole/stabiliser in ground dug out which is in concrete. Need new clothesline stabiliser put in ground and concreted in (tasker to supply concrete). New clothesline installed and operational.

star droppers will be supplied , I need 8 star droppers hammered into the ground to hold up a fence

Install pool gate lock including hinges

I need a Stratco gate installed. Have all the parts, gate and steel poles. It’s about 800 mm wide, and needs the pole bolted to concrete and then the gate latch on the brick wall on the other side. Or, could go in reverse: gate attached to the brick wall and the latch on the steel pole near the fence. No time waste is please, need someone qualified.

Install a panel as per photo using the existing post on the right and using the fence rail( inside of fence) and dynabolt to driveway floor using bracket to install another post to the left . Then fixing panel aligned with other panels to the right. It will be easier when you see the job. Ladder provided if needed. Please work quietly as is my elderly mum's house and do not be bothered by nosy and unfriendly tenants renting next door. Just focus on the job and u can not go on their property. You might want a quick look first and if different screws or bracket is needed I can purchase ready for installing. The panel is quite long so when fixing you can temp use a screw to hang one side to make it easier when securing the other side . You can work it out, an old man attached the three panels to the right on his own in a few hours. Just to be clear the panel is to be installed inside the black gate to the left towards the inside gate.

Need a pool fence gate with latch to be installed. I don’t have any of the materials, but the basic fence can be purchased from Bunnings with the fence post as this is where I purchased the other fencing from that you can see in the photo.

About 2 inches needs to be cut from 6 foot tin fence, on both sides(includes metal railing)

Assembly and install of a stratco ezi-slat carport gate with self latching walk through gate on one side. Will need to cement in three posts, cut blades (just a single cut for each) and put it all together. All stratco parts and fasteners are ready and on site. Images are of the space between the house and the property line fence where it will be installed with the gate drawn roughly in blue and fence posts in red and of a similar example of what it will look like from the internet. Space is 3.6m wide and gate will be 1.2m high. You'll need your own insurance and all tools and materials outside of what stratco provided. Soil is rock and clay.

Picket fence with one post to be re-attached and others with screws to be tightened. Screws supplied.

Hi, I'm seeking a quote to get my side gate fixed if possible. The gate latch seems to be mis-aligned. Pictures attached.

Wireless keypad was knocked off gate and needs to be reinstalled