Find experienced local fencing contractors in South Brisbane

Replace a back wooden picket fence

Supply and install a new wooden fence approx 19m in length x 1.8m height.

End part of timber fence leans . Need to fix it .

100 meter color bond fencing

1-installation only 30m color bond fence 2-Supply and installation 30m color bond fencing Looking for best offers

8 fence panels need to be replaced cement sheeting panels Hard to say a price to pay it will have to get a quote.. I just put $1,000 to get through I understand could be more or less in the quote

I will be having 10 posts removed (concrete) and replaced with narrower steel posts. The facade of battons at the front of the house will need to be re attached appropriately to allow for 2 gate functions and the rest fixed.

Timber fence on side of house need replaced approx 5 metres length.

One section of front fence is quite flimsy, just the area with the letterbox on attached to the gate. Might need a bit of concrete or a new post? Further photos attached of the bottom of the post.

Move already made wooden fence gate to another part of the fence and replace hole

Replace the old fence panel with a new piece. You will need to cut the new piece to fit and fix it into place.

Timber fence. Span 320cm. Height 120. Three vertical post holes with concrete required. We have all the timber material, post mix concrete, nails.

We need fence pailings installed on our side of an existing treated pine fence (new, refer photos). The fence is approximately 10 meters long and 1.8 meters high. In addition, we’d like the top of the fence cut with a circular saw/straight edge to ensure it’s consistent and level. Details: • Treated pine fence. • Approx. 10m long, 1.8m high. • Easy access to the site. We’re looking for a professional and tidy finish. Quote to include materials and AirTasker fees.

Remove and reinstall gate, and small fence onto side of chicken coop. Have all additional supplies, may possibly require further screw accessories.

I am looking for someone to source and install a side gate at our house. Preference timber that can be painted white. Width is 2m and would like 1.8H . There is a 50cm x 50cm overhang on one side of the fence (garden beneath the side of the house) that also needs to be filled in.

Front timber fence was smashed from car. We do not want a brand new fence but just for the fence to be restored to previous state (i.e., standing up and palings all in good condition). Some of the palings were damaged from the car unfortunately. We would appreciate if this could be fixed ASAP. :)

Hello. We need advice on a new double gate for the driveway. Existing is powder coated aluminium (I think) but happy to consider your recommendations on cost effective replacement.

Complete cat proof fencing. -Run wire rope 12 meters. -Attach 6 meters of chicken wire to 2.2m star pickets with right angle brackets on top. -Attach 10 meters of chicken wire to 2.5 meters to the top of star pickets and right angle brackets. -Drive one star picket in to the ground. -Put up wooden brackets which will have to be cut down to size. I have the treated pine. On top of the brackets needs to be either colour bond or corrugated roofing plastic. This has to be on top of a colour bond fence and stretching about 6 meters and 1.8 high and another 4 spots 1m x 1.8 high and attached to concrete. - the existing fencing needs to be tweaked and secured. So tightening wire ropes, using tie wire and c-clips in areas. -a pet gate to be put in one spot by being slid in between pre existing star brackets. Then tie wired on. -Balinese screening to be tie wired to shade cloth -thunderbird electric fence topper to be but on 50 meters colour bond fence. This consists of putting up 20 plastic brackets and threading wire through twice. - you will have to pick up the gate I have pre-paid for along with the roof sheeting. I have a ladder but you may need a taller one. I have a star picket driver and most of the fixings I have too. There is a bunnings 5 min drive away so I can always go and collect anything on the day needed. Please only take this job on if you are familiar with working with chicken wire and temporary fencing. It must be secure and look very presentable. Any zip ties that have been used must be snipped of and replaced with tie wire. This job is suited to someone who is familiar with this work and likes to make things look nice as well.

Looking for a handyman. needing 4 star picket taken out of the ground and about five Star Pickets put in to the ground in a different, these are 2.4m. My friend and I have already put in nearly all of the star pickets and brackets on top (to cat proof mums yard) Some of the star pickets and brackets need wire rope to be fed through the holes with clamp/ grips and turn buckets to keep the wire rope taught. Over the star pickets and brackets needs chicken wire with c clips or tie wire. There is also a small section where some bolts need to be put in to brick work. In addition to this I need the electric wire fence topper which runs along the back of a colour bond fence (100m) it is designed for dogs and cats to not escape and is very straight forward to install. It is powered by AA batteries. This job is suited to 2 people and someone who has done temporary fencing. The first section is done so will be easy to copy and follow for the rest. I have all of the material and a ladder as well as a manual star picket driver but you will need all of the carpentry tools. I have the material but you will need the tools. I need this to be completed by Wednesday the 7th of August

Timber fencing required for house, 1.8M high.