Find experienced local fencing contractors in Springwood QLD

Six metal posts bottom part got rusty, they are under patio, need to be repaired/renewed. An estimate price would be much appreciated. Thank you!

We knocked down an old brick fence and need the concrete footings dug out and removed.

Colourbond fence is leaning to one side (neighbours side) and flimsy and needs to be stabilised and fixed asap. There needs to be brackets between the posts and not just the side. Need a professionals help please who will do the job right and fix the issue properly. Pics attached (house is left side)

Colorbond fence recently installed, not installed properly. Contractor now unreachable. Needs to be rectified

Hi, looking for quotes to remove wooden fencing and replace with colourbond fencing along two sides (final pic shows one side already done). We can help if that keeps cost lower and we can also pre purchase materials if that makes it cheaper for us too. Not sure of exact size pls don’t ask. When I’m home I’ll measure and update post. Needs to be done by June 2024

A handyman is required to install colorbond fence and a small patio. 60 bucks per hour will be paid. Minimum 3 hours. All materials supplied.

A very small part of fence needs to be erected. Two holes have already been done and posts have been installed. Just one more hole is required to be done. 2 hours considered for this job. All materials will be provided.

We're installing a new fence, including a pool fence around the pool and equipment, with all necessary screws, panels, and posts supplied. Please ensure compliance with the Queensland pool safety standard.

fence to be 22m. And 5m of that needs a small retaining wall with concrete 30cm high(due to the difference height between my property )and want to reinstall colorbond. Suburb is Logan brisbane - Due date: Before Sunday, 24 December 2023

Colourblind fencing In color Jasper, location spring wood , slope area - Due date: Before Tuesday, 19 December 2023

INSTALLATION ONLY, I HAVE THE MATERIALS. I need 4x 2450mm flat top aluminium pool fence panels installed. 1x panel to make 2 short sections and 1 gate. The posts need to be core drilled except for 1 in ground. The fencing and grout will be onsite for you. There is a straight section of 9450mm then a 1000mm return and then 1450mm gate section - Due date: Before Wednesday, 1 November 2023

Supply and install min 1.8m high powder coated horizontal slated zero gapped aluminium fence, motorized 2.4m sliding Gate and 1.2m key locked pedestrian gate. Approximately 6m panel, 2.4m motorized sliding gate, 11m panel, 1.2m pedestrian gate with flush dead keyed lock, 9m panel. Post size powder coated steel post min 75x75, 1/3 length in concrete footing, spacing no more than 2.4m. Conduits for power and lightings at gates posts. Built in A4 letter box. - Due date: Flexible

1. Removal of existing chainmail fencing. 2. Installation of approx. 10m of Colorbond fencing and posts - already on site ready for installation. 3. Clearance and disposal of all removed fencing material. Note: access available from both sides. - Due date: Flexible

Cut a few inches of colourbond posts, (4) cut 1 sheet in half.

Hi Rod You interested in quoting for a full replacement of a small pool fence, on side of house, which joins a boundary fence. Total length is about 4.5 mtrs plus a gate. I'm looking at replacing with a flat top protector fence and gate from bunnings which I will buy and have delivered, unless you have a vehicle that can go that [ include in your quote and specific if you can] Will need to dig two holes for posts and the two posts for the gate will need to be dyna bolted to concrete pad surrounding pool. I can remove the existing fence prior to your arrival, though if you have the means to take to dump can you include a figure in your quote for that. With the set up of the fence which is in a garden bed next to concrete pad surrounding pool I'm not sure about the appropriate distances about ground with the fence product I am considering. If you provide an email I will send through photos. In relation to timing it would be nice if it could be done prior to 26 Jan but it's not a deal breaker. I'm retired and will be home and can assist as required. I'm not totally useless and have built the timber fencing around my property my self. Looking forward to hearing from you. I'm also after some advice re ensuring the rest of my fencing is compliant, Regards Craig

4 x 3 wooden fence and a gate to be installed. I have the Materials ready for cutting and installation. Next to a pargola . - Due date: Flexible

5700x2800 L shaped fence with 950 gate Require measure to quote. Need ASAP due to pool compliance - Due date: Flexible

Removal of temporary fence at the back of a carport and reassemble it at the front of the carport. This is an extra precaution to contain our dog. - Due date: Before Thursday, 1 December 2022

Remove and dispose the existing colorbond double gate along with another colorbond fence panel attached to the gate - Due date: Flexible

I need a section of colourbond fencing removed and relace with a gate (open inwards) and lockable (1800 x 900). Depending on quality of work, more jobs available. - Due date: Flexible