Find a professional garage door installer in Gold Coast

I would like someone to come & insulate garage door. I am a pensioner, will there be any discount. I am on a budget will pay cash

Garage door leaves a small gap needs to be fixed please provide a quote

I have a new garage door opener requiring fitting to the existing rail and bracket. The new opener is the same brand and model as the one being replaced.

I believe this can be taken in for scrap metal. Handy person will need to have experience with removing this type of door as it is spring loaded.

Wanting someone to paint my electric garage roller door white to match the rest of my house

Just looking for someone to come and take away an old garage door. It’s not that heavy could be done by one person. It’s about 3.05m long

Garage door fix Not closing evenly a couple of wheels are off the rail also one side wire is off as well.

Garage door wont close..rolling uneven

My garage door is broken and I can't close it. It's stuck in the open position

I have 4200L x 2100H glass doors I would like installed in the 4700L x 2100H opening where my current garage door is . I would someone to have a look and quote it up for me please and discuss install

Garrage door not working

Need someone to purchase pictured lock (or similar) and install on door in Miami by lunchtime today if possible ?

I need someone who can help me to setup tye remote for the garage door

Need someone to install an automatic double garage door opening motor. We are going to buy the motor and only need installation. Please do not quote for the motor as well, only installation as we have the motor. Need done this week ASAP. Just remember, just need installation cost and not the cost of a motor

Fix strut on garage door plus some dents on the front.

I paid for this remote but couldn’t figure out how to get it to work as it’s not programmed yet

Old and rusty garage need to paint.

I have converted my garage into another room by putting sliding doors in. I now need to remove my old garage door. It is a double garage door with 4 x panels. The trickiest part will be removing the tension springs. You will need to have a set of the winder bars to safely detension the spring. I’m more than happy to be a spare set of hands.

The cable at the side of the garage door came off the roller so my husband has loosened the rollers on either side and the pretension spring has unwound so the cables are now free though the spring needs to be retentioned and the two rollers tightened back in place.

Need the torsion put back into the spring, the cables on both sides replaced and spooled back onto the spindles. The central bolt from the arm and chain drive put back in, then just a calibration. Everything has been well used and operational, is wired up and good to go. Photos supplied.