Hire a trusted gas stove repair and installation service in Ferntree Gully

Gas plumber needed plz! I have a freestanding cooktop at the moment and want to replace that with a bench cooktop, the freestanding one need to be disconnected and connection of the new cooktop when put in place, thanks

Couple of gas cooktop burners not working

Gas cooktop needs to be change from 600mm to 600mm. Swap over. - Due date: Flexible

I need install B26 rinnai instant hot water heater and gas compliance certificate+ range hood compliance including the exit from roof for one site in ferntree gully + 2 outdoor taps + gas cooktop connect to the gas line (it is already installed just have to connect) - Due date: Flexible

Disconnect gas from St George CG60 cooktop and fit and connect gas to Chef CHG 642 / 644. Just looking at pricing at present. - Due date: Flexible

We have a 60cm Gas cooktop that needs to be removed and a new one installed . We need a licensed gas plumber who can provide us with gas compliance certificate. - Due date: Flexible

We have a 60cm Gas cooktop that needs to be replaced. We need a licensed gas plumber who can provide and replace the existing gas cooktop with a new one and provide us with gas compliance certificate. - Due date: Flexible

I am going to install a new 900mm gas top to replace a 85ish gas top. I think the benchtop need to be modified to match the new size. So please let me know your quote to get my new gas cooktop working. the current opening cut size is roughly 830mmx480mm. The required size of the new bosch cooktop could be found in the attached photoes. with regard to the benchtop size,it is long enough, but the width is around 580mm. Please let me know if you have any questons. Thank you. - Due date: Flexible

The last gas device in the house is currently the gas cooktop. We are planning to replace it with an induction one, so we'll need to remove existing gas cooktop, and relative piping (remove and cap gas). - Due date: Needs to be done on Thursday, 19 January 2023

On my gas stove, all the burner's ignition spark continuously clicks while I switch on one of the knobs. I don't think it's because it is dirty as the stove has not been used for a while. I suspect it may be the spark ignition switch, which may have "shorted". I need someone who can help troubleshoot and fix the issue. - Due date: Before Monday, 2 May 2022

I have electric gas cooktop and want to change it to Gas cooktop Thanks

Old Stove, Dimension 975mm x 460 mm Three out of Four burns couldn't ignited. Hard to find / very expense to replace the same dimension stove. So hope to fix them first - Due date: Flexible

Old gas cooktop removal and install a new one / second hand one. Old gas cooktop dimension is 975mm x 460mm, and the hole for the stove dimension is 900mm x 370mm. Prefer to buy 900mm from the market, but will need someone to install it Dishwasher need to be removed and changed Electricity Oven need to be removed and changed

Hi, about to pull out gas stovetop from an island. Needs disconnecting with view of being moved to side of kitchen, about 1.5-2m away, about where the dishwasher currently is. Room under house for access.

Plumber/ gasfitter required to disconnect gas stove and cap off at meter.

remove old gas cooktop and replace with a new gas cooktop in a laminate bench top. Need a certificate of compliance

I just purchased a new gas stove cooker to replace an electric one and need a plumber to connect up and install gas line