Find a professional gate installation in Bentleigh

The latch of my front gate has broken and so I am unable to close the gate. Pls refer to the photos

Paling fence 14 metres with gates .. hard wood posts to be minimum 700 deep ..decent thick plinth ..galvanised nails on palings and 4 inch galvanised screws for rails ..old fence and gate to be removed and taken away ….. gates and door area is about 6 metres long …

I have a Mitsubishi asx and need my new tail gate and rear bumper installed which I will supply all the new tail gate and rear bumper and all tools required

Please see photo of example and then photo of my area

One side of a duplex townhouse, would like to install a sliding automatic vehicle gate (marked blue), at maximum possible height 1.5 metres, and a pedestrian gate (red) and optional extension of the middle fence (green). Would like to get an estimate. Total length at the front is around 7.8 metres. Attached is the photo how I want the gate to be. Thanks.

Two gates need repairing, currently mot self closing and one gate not in alignment .dates flexible but need done by Wednesday next week. One gate will need to be fully installed , picking new panel up today . - Due date: Before Friday, 9 February 2024

We want to be able to access the patch for our gate from the outside. Currently there is no hole to put our hand through. We need a neat hole with sides of colorbond folded in so not sharp etc

Gate in driveway to keep dogs in and one around the side of the house … Steel preferred approx 3 meters long and chest high - Due date: Flexible

Pool gate needs adjustment and minor repair. - Due date: Flexible

Need to widen entry to house for construction. Want to remove electric sliding gate and retain for future use. Also need to remove a small section of wooden front fence and if comes down in one piece will reuse that also. Metal pole which is part of the sliding gate set up also needs to be removed. - Due date: Flexible

Gate post needs foundation reset. Workers disturbed base and is now loose. Needs foundation reset to make post vertical so gate can close. - Due date: Before Saturday, 22 July 2023

2 gate hinges have rusted and need replacing. Already have the new hinges and need someone to install them. - Due date: Before Saturday, 24 June 2023

Front gate is getting stuck on other gate as it has dropped in height. Need someone to fix this back to original function. - Due date: Flexible

Need a fence with the same timber type - Due date: Flexible

I have an aluminium slatted gate 1800 x 1000 approx. Needs to be installed between the side of the house and the boundary wall. I also have the 2 posts for mounting. The posts still need mounting holes drilled. 1) Install 2 posts 2) Mount gate to post with hinges provided 3) Install latch on other post. The boundary wall is fibre cement sheeting and will need a spacer at the top mount as it's not 100% vertical. The hinges and latch come as a kit so have all screws etc, but other hardware eg wall anchors need to be supplied. - Due date: Flexible

Component of Circuit board has blown that operates the electric date. Need fixing asap - Due date: Needs to be done on Friday, 27 January 2023

The bottom of the right gate (red circled) scratches and stuck on the ground making it very difficult to open. Right side of the steel gate post came out of the hole and need to be concreted back into the ground - Due date: Flexible

Replace driveway gates with a swing gate - Due date: Flexible

Remove one pillar and add swing gate yo make easier to reverse caravan into driveway.

Swinging timber fence gate needs repairing. Out of alignment and no longer latches to close - Due date: Flexible