Find a professional gate installation in Caulfield North

Install 2 x baby gates into issue reveal of stairs (top and bottom). Install 2 x outside security cameras (battery powered. Move painting into centred position in bedroom wall

Install security mesh screen to front gate

Paint front gate per photo. Paint has been purchased.

Hi I need someone to help out digging small area for tilling and adjust a gate too. Tree roots need to be cut, tree stopper placed and cement it back with new tiles. The gate needs to be cut from himges and be put new hinges to lift it up as it is bit angeled. Tiles and cements will be provided. Please quote your price. I will be helping wthere too.

Install 2 monument colour bond privacy pedestrian gates , 1.8m high. One gate 1.2m wide, other approx 975. Set posts in concrete and provide locks

“Press to exit” button for mechanical gate release is broken. Button is fully pressed in and won’t release. Needs fixing / replacing with new cover plate.

I have a Golmar Soul Gate station with an external gate release button but I have to run to the gate to reach it in time to open it after I push the button. I would like to increase the delay to allow me to reach the gate easily.

The part that hits the strike is jammed

Refer photos. The gate has a 20x20mm hollow steel frame with two steel hinges which have broken and need replacing. I expect the hinges will need welding to the gate frame and are unsure about how the hinges will need to be fixed to the gate post.

I am open to either you supplying or me sourcing the hardware. But need assistance in installing.

Remove and replace post that is cracked and then reinstate electric gates to full working order

I need help to install a gate latch for the side of the house. I removed the old latch and this one needs a new set of holes drilled. You will bring your drill to make 13 holes: 4 mm and 13 mm in size. You have a steady hand and are able to measure to requirements.

Install a baby gate to prevent going up the stairs

Install APC retro reflective sensor on sliding gate. Safety sensor for gate opening system. Wired at Control Box Side Only (with a reflector for the other side) Gate Sensor

I need a lock plate installed and supplied on my front gate

3.7 paling fence in length. 2 plinth, 1.8m paling , 900 trellis . And a gate within the fence

Ground floor flat in masonry building has a 2.5 m balcony about 0.5 m from the soil, with a 1 m high black decorative metal fence. A similar flat on the other side of the building has removed the metal fence and replaced the plants with pavers (see photo) and more recently placed two steps against the masonry to convert the balcony to a porch and second entrance. I'd like to do this as well but remove less of the vegetation and have a locking gate replace the fence at the top of the steps rather than remove it, because of occasional child care.

Remove previous lock and replace with new lock unit.

We have a sliding front gate that is partially covered by a panel (see image) 110x75cm. We need someone to cut another identical/very similar panel, then weld it to the upper part of the gate above the latch.

Top hinge needs to be re-aligned. Lower hinge is off and there is a bend in one of the metal beams. At a guess metal is aluminium