Find a professional gate installation in South East Perth

In need of a cream colorbond side gate. 1.6 m wide. Preferably done soon.

I would like to have a sliding gate installed across a drive for an existing fence. I have the gate with attached toothed section, motor and some hardware (see photos). The drive slopes towards the road and to the right (viewed from the road). It is very important that the gate does not roll by itself.

My side gate is not closing, I need to get it fixed..

Hi there. I need this gate covered with proper brushwood panels. The gate is 3m wide (each side is 1.5m) and total height is around 1.7m. I have temporarily put cheap Bunnings stuff up to stop people looking in and the dog constantly barking at people walking by. I would need you to supply the brushwood panels and topping etc. Please only quote if you have worked with brushwood before. Job must be done before November 17.

I am looking for a quote to supply and install a pool fence gate for my backyard corridor. The corridor width is 1.5m.

A standard wooden Garden gate ( Bunnings) fixing to wall creating to close off alleyway between house and next doors garage making it more secure

Install gate in side wall

Remove old hatch lock and padbolt on colourbond gate. Install new hatch lock and padbolt( supplied )

I require a driveway gate installed with remote opener and closer swing arm. Total width of the area is approximately 3350 mm will prob need a small side panel too. Also need a personal access gate with key lock for other side of complex. Approx width 2200mm Looking at either guardian style fencing or Ali vertical slat fencing.

Attach existing gate frame to outside wall and replace latch. Front side gate, replace latch. I would like a quote for fencing to go around the border of the front of my house.

Hi I need a hilux tub and tailgate gate plus a few pieces of portable dog fence removed asap

Car banged into the gate. The gate is slightly bent in one spot and has derailed. Need fixing.

1) Install aluminium barr balcony balustrade - x 3 Barr panels; x 4 posts fixed to balcony floor, which comprises of 12mm porcelain tile on concrete base. 2) Install aluminium fence gate and 2x posts fixed to patio floor, which comprises of 20mm paver on brick base.

I’m looking for someone to do side gate for my new home.

Current color bond fence install is 1.8 x 1.8 m (Both ends are brick wall as shown in pic) Need to install slat gate width apprx 1 m (DIY Kit with post and accessories will be provided). Door Lock shall be pin pad (it will be provided as well ). Remaining leftover area will be covered and fixed with existing color bond fence with existing fence sheet by cutting. Scope Assemble DIY Kit Remover Pavers and fix door posts with wall and ground Install the door with hinges Install the door lock provided Cut the existing sheet and cover the leftover area with color bond sheet fence any further queries can be asked

Self closing gate doesn’t close itself

I have a glass pool fence that requires gates installed. I have all components here, glass panels with pre drilled holes, hinges, locks. I have 3 gates in total to install, plus 1 glass panels inserted. Gate 1 - install complete gate hinges drilled into green pole, lock onto fence Gate 2 - swap glass panel into same position. Gate 3 - swap bottom hinge only Glass panels - install glass panel completely.

Electric gate is playing up. I believe it’s the switches that toggle the motor off when the gate gets to its open and shut positions.

I need to replace the gate latch for my pool with a new one. I have bought the new gate latch, this job would just be removing the old one and replacing it with a new one. You will need your own tools and might have to drill some holes into the gate post.

Front gates were damaged by an unknown vehicle. Need to repair or replace so the property can be locked.