Find a professional gate installation in Victoria Point QLD

Make a gate Hey how much for a 1200H x 2100W mesh gate.

Dear all, After recent storms (when I was on holidays), water leak has appeared once I am back home. I am looking to get it rectified (a bit of ceiling plastering involved too as the effected patch is now swollen, please see pictures). It is low set one storey house, roof is accessible via ladder inside the house. I have got standard tiled roof. For your information, enough pictures posted here. - Due date: Before Tuesday, 9 January 2024

Build a timber picket gate to match fencing on either side of opening - width 1030mm, height 1300mm. - Due date: Flexible

Hinges on gate were broken so it would seize and then came off hinge so wouldn’t open/close properly. Removed gate entirely for machinery to come through for backyard. Need existing gate put back on. I’m unsure what additional parts other than new hinges required to get it back on? - Due date: Needs to be done on Saturday, 28 October 2023

existing steel gate is not closing as compliant with swimming pool requirements either gate needs adjusting or new latch - Due date: Flexible

Install a doggy door in a security gate - we will supply the doggy door.

we need a side gate and supports replaced, this includes supply material and concrete in posts. Removal of old material also please. see below comment from current tennant... Needs 2 x Treated Pine Side Fence Panels (2400mm x 1800mm) and Replace 2 x Gates. (1500mmx 1800mm). On Inspection the Posts are Rotted out at Base, the Palings and Rails have Dry Rot and the Existing timber Frame Gates are badly constructed and are beyond Saving - Due date: Flexible

Supply materials and construct Brick Gate pillar (replacement for damaged pillar). 360 x360x1300. Render both pillar and fence base adjacent to pillar. Insurance job. - Due date: Before Friday, 30 June 2023

Side access needs a slope of 20° to the draimage pipe which is already in place. Half finished but lack the skills or equipment to finish. Will need packing down and then laying out weed suppressing matting. Shovelling aggregate into drainage channel. - Due date: Flexible

Existing wooden back fence modification to include discrete gate. Fence has 3 cross rails. - Due date: Flexible

Need to separate the yard in to two by installing two new fences running from the house to the boundary fence, + two small gates - Due date: Flexible

My Solar auto gate atopped.working after the masive rain we had last week, I need a elextric gate technition at my house to complete a root cause analysis and get the gate functioning again, Currently we are opening the gate manually. My Address. 10 Hibiscus drive Mt Cotton - Due date: Flexible

Have pool glass gate that needs to be re attached to fence and stone cladding pillar taken off as had house painted on the outside

The tracks for our sliding gate across the driveway aren't level (the concrete it's sits on isn't level), so the gate doesn't roll properly and gets stuck. The tracks need plastic packers under them to get them level, and some new holes drilled in the concrete for additional screws to hold it all down properly. (Most of the old screws are pulling out of the concrete) The magnets for the motor stopper sensor also need attaching to the rails. It's a fine hole (3mm) through the solid metal centre of the plastic coated rail so needs a decent drill bit to get through it. Probably one to 2 hours work.