Find a professional gate installation in Yatala SA

I need a replacement driveway gate and a side passage gate Need materials supplier and installed

Install side gate. May need a new post on one side. Other side can attach to brick wall

Looking to get a quote for the following: - rendered block or brick fence in white - black tubular aluminium infills - single pedestrian entrance, black tubular aluminium - sliding gate, black tubular aluminium Please see photo for rough design and measurements. If you can only do the fence but not the gate then please specify.

Our gate is broken, it needs to be replaced It doesn’t close. The lock side is coming out of the plaster

It was a gate connection before but when trade person came to fix gate they damaged connection

Our existing swing gates have started to sag and scrape along the paving of the driveway. Removal of rotting timber gate posts and installation of matt black steel posts (new posts to match existing fence posts along the front fence, 120x120x3mm approx, flat capping on top to match other fence posts). Steel posts to be concreted into the ground. Existing metal swing gates will need removal from the old timber posts, then reattached to new steel posts and adjusted to achieve an even and flushed closure. Existing automatic opening/ closing gate motor will need reattachment to gates to reinstate original function. Please state your licences, ABN and warranties on workmanship and posts supplied. Please supply photos of the new steel posts you intend to install. Thank you.

Fence height 1.5m , 10m frontage of my house needs blade electric fencing 406, motor 966 and required concrete 895 with side small door.

Metal Gate Weld and Repair new Hinges onto Gate (rusted/snapped) Drill Hole in Concrete for Lock Pin Repair Metal Fence Post on side Fence that has snapped off at base in the wind

Shed roof, 2 corrugated zincalume sheets approx 2230mm to be fitted to shed roof, replacing perished suntuf sheets in 2 spots (only 2 sheets to fit & they will be delivered on Monday some time) possibly fix/replace a roof ventilator (spinaway thing)at the same time. (Also supplied) Available as soon as delivered Monday 20/1 anytime till 22/1. It's only a little job, just want it fixed. Pls advise on $ & when you can complete the job.

I need a metal post cut shorter then bolted into brick wall. Second job I need the gate latch removed from its current place and lowered and bolted into brick wall again

I’m sick of reaching over my gate to open the lock, I just need someone with a hole saw to place a hand sized (around 120mm) hole in the metal gate (colourbond style metal)

I have motor fault, no limits set, have tried fixing few other things but seems like gate is not working when on auto.

I have a glass pool fence and gate. I'd like to get the hinge replaced with one that is soft close. Please quote including cost of hinge as I don't have one.

Gate latch screws have come out. Will need some bigger screws or ideally some type of screw that fastens from the inside of the steel gate. There’s no room to put nuts on the inside of the gate. Open to ideas.

I need new front gate remotes pls supply remotes

Hi I’m looking for someone to help with either building or buying a gate, (I will cover materials) for the side of my house including putting the gate up, width 137cm wide would prefer min of 5-6 feet high thank you

The Kitchen tap flow of water has weakened, not happining on other taps so probably specific to that tap or pipes leading to it.

The Latch for the side gate has come loose and fallen off. Not sure if it can be re-attached in place or both sides need to be removed and re-drilled in higher/lower

Hi, I'm seeking a quote to get my side gate fixed if possible. The gate latch seems to be mis-aligned. Pictures attached.

Wireless keypad was knocked off gate and needs to be reinstalled