Find a professional gyprocker contractor in Ryde

For a double-story house, I need to replace broken roof tiles if any, replace and clean all the old gutter nets with Aluminum alloy gutter nets as shown in picture 4, and fix the ceiling broken gyprock as shown in picture 3.

Ceiling and bulkhead framing - ceiling about 60mm drop bulkhead is about 180mm wide 400mm drop average / recess along the bulkhead for LED strip The bulkhead is about 2m long and about 7sqm of ceiling . Set and sanding and to be ready for painting . You need to use water resistant plasterboard for bathrooms .

Require holes (including anchor/screw holes) where aircon has been removed to be repaired/patched, sanded and ready for painting. Photos attached for reference and pricing.

We need to remove 2 temporary wall they are both made from gyprock and very easy to knock down

Gyprock wall 65”tv I will provide bracket

Add a gyprock ceiling to a laundry roof (exisiting ceiling cement). Room is approx 3x3m. Needs to go around existing cupboards and ceiling mounted clothes line.

I want to make a gyprock wall (2660x2200) and make an entry (arch shape) to the existing gyprock wall.

Repair and smooth out the gyprock patch in the garage

I need 5 holes set, plastered and sanded ready for painting. Gyprock off cuts have been screwed in 3 of the holes have a set on it but I’m not sure if it’s suitable for the job I will paint myself

The current roof of the under staircase storage is timber stair frame, and it needs to be covered with gyprock and paint.

I need an internal wall (non-load bearing) to be removed and gyprock applied along with any cornices / joint compound etc) and ensure the wall new area is ready for painting. Would like a certified builder ideally.

I need the kitchen area to be smooth for new kitchen and a few patches on walls around skirting area to be repaired.

Need some ceiling gyprock hole x 2 approx 20 cm diameter. Small white ceiling paint over sand. Handyman small jobs also.

3 brackets & TVs to be mounted in 3 separate rooms. I have purchased the brackets from Bunnings already. Walls are gyprock

Need to patch up the Gyprock in the roof as per image and paint it to tidy up.

one laundry and one bathroom ceilings, gyprock work around the windows `. one laundry and one bathroom ceilings - setup a new door frame one of the bathroom. - top window edges around the house need gyprock/mesh to allow acrylic render to stick, - gyprock work for a new door - gryprock work damed wood trim for a skylight Best to visit the site at Epping for accurate quotes

We need a new bulkhead made to cover the gap above a new cabinet 310mm x 1040mm with two wides exposed. We will need 2mm of the cover panels on each side cut down or notched out a little as we missed measured when we installed the cabinet (you can see this in the photo) Then for another cornice we need this fixed. We hired an AirTasker who came to add an extra bit on (the unpainted part) but he didn’t buy the same cornice size so it looks very different now - he tried to say we can paint it and it’ll look fine but we’re not convinced. Also did a pretty poor job as there’s gaps as well. So either someone to change the whole cornice or fix what he has done (length is 2900mm long. See photos. We have a brand new full sheet of plasterboard, long and short trimex metal trims and also a near new pot of acrylic stud adhesive leftover. But please indicate what you include in your quote, Budget is just a placeholder as AirTasker won’t accept leaving it blank

Cover with gyrock the hole/ void in the ceiling due to a skylight to be removed and from removed kitchen exhaust fan

The Ceiling plaster board is cracked. My husband went into the attic to check water leak and accidentally stepped onto the thin plaster board. Need replacement and painting. Measurement is available on the photo.

Need someone to help with fixing our cornice after we ripped out an old wardrobe and installed a new shelf. We already have a piece of matching cornice as per the picture and full size trimex angles In summary here is what needs doing: - Approximately 1300mm of gap between wardrobes and cornice needs to be patched - Cornice needs to angle inwards to meet the cornice on the wall and the cover panel needs to be cut so it sits flush with the cabinet (we forgot to get our handyman to do it so ideally you can but if you can’t and don’t have the tools we can call him back - please specify in your offer of you can do this part!) - patch hole in cornice as per photo Please specify what your offer includes and when you can come, would like this done as soon as possible. We also have a brand new full size sheet of plasterboard of that is required