Find a professional gyprocker contractor in Sutherland Shire

Supply and install Gyprock setting and cornice - standards cornice 10x100 No sanding needed Area is 3.0m x 8.0m

Small bulkhead area to do one sheet of Gyprock is enough

I need a handyman to mount my TV on a wall. No problem drilling holes in the wall. Metal mount supplied, but please bring your own anchor screws to attach to the wall. At least 6-8 will be required as it’s around a 60-inch TV. Please include the supply of your anchors in the agreed price.

There are currently 2 x bedrooms and a walk in robe needing the gyprock to be set and sanded ready to be undercoated and painted

Need to install 6 x sheets of Gyprock 1350x3000 to garage ceiling. Access is easy as there is a mezzanine about 1.3m from ceiling. Old ceiling will need to be removed no disposal needed.

Four small jobs: 1. Cut back entire ceiling of small ensuite and replace with new gyprock sheet + new cornices (2680mm x 1000mm). Small patch ripped out for bathroom repairs but whole ceiling/ cornices need to be replaced. 2. Repair gyprock / cornice patch in ceiling in the office (small patch as shown). 3. Repair damaged cornice above front door entry. (Corner only) 4. Fix up new drywall/gyprock patch already installed, with filler and sand back ready for paint. We will paint it. (Patch 1000mm x 300mm)

Extending the opening of exisiting cupboard cavities in 3 rooms and closing a doorway

I have about 6 (light switch sizes) holes to close and patch + 3 big one ( about 20x20cm) and another patches to do. Please see photos for details.

A handyman is needed to patch gyprock: 1. Corner of the wall and the gap next to the floor 2. A joint between two gyprock sheets 3. A hole from the old light fixture 4. A hole from the switch plate 5. A hole on the wall which was covered up with plaster 6. Cover a hole between the balcony beams and the wall to block rodents access (a ladder is required)

Need wall and celling done, the area is approximately 145-150 m² with a ceiling height of about 2.7 meters throughout. job may start may 2025 - house not ready yet

Double glass frame to be installed on wall. It’s around 10kg. Hardware provided, own tools needed. Studs will need to be located for install.

Patch up some holes in my walls and plasterboarding.

Small laundry room (6sqm) needs to be set and sanded on the inside and outside of the room. The ceiling will be square set, materials will need to be provided

Plasterboard up three rectangular spaces in wall in ensuite

Labour only . Install 2 .7 metre wide stud wall and gyprock and set and sand (2.7 m height) with door jamb, hang door, install architraves . Paint wall and door , door jamb architrave

10kg framed jersey to be hung up on Gyprock wall. Was told to have two wall mates that hold 10kg each should do the trick

Assist with setting gyprock and setting cornince

I need gyprocker replaced 2000x1500 x2 on large wall x2 cut outs set and sanded then paint whole wall mirrors have been put on either side of the TV and I have to remove them and damage behind mirrors when I remove them only need to be patched but worst-case replaced Chiprock. I will send through photos of the mirrors that were placed next to ton either side. So there are two mirror that I put up on wall about 2.1x1.4 (x2) and when I take them down the wall is going to be ruined as l used liquid nails so either replace the gyprock behind it and and set and sand plus paint Wall is 7mx2.7

a room that has been gyprocked will need joints to be plastered

Ceiling skylight has damaged gyprock from a previous leak. Leak has been fixed but gyprock is damaged.