Find an experienced handyman in Bonnie Vale

I need a painting and artwork put up on the wall

Spotted gum deck has 800x 800 hole where tree grew through. Tree now removed. Need frame up hole and fit and screw new boards in place.

Wood panel and mirror instalation I would like to do it asap

Install two s-track curtain rods into brick wall. Just below cornice.

Need to have refrigerator doors removed. I do not equipment or strength

There is a small gap 1.5cm wide and want to make it look flush and repaired Ask: fill gap and any other work as required

Looking for someone to simply install / lay 3 pieces of 13mm plaster boarding / gyprock to existing ceiling with NEAT and EVEN finish in my bathroom. 2 sides is just laying gyprock over existing ceiling and to tiles , the centre where you see light fixture needs spaces to make level and then just gyprock applied. 3 sections - measurements 73x180cm 97x180cm 81x180cm

Need a bulk head installed at top of wardrobe and cornices extended to meet it.

I have a window in my dining room and the living room that needs to have curtain rods hung

I have been given a Mac book pro and the Touch Bar is glitching. I am desperate to have this fixed as soon as possible. please let me know if you are able to replace the Touch Bar and cost.

Ordered a blank internal door form bunnings and will be delivered apparently on Sunday. Also got handle assembly and hinge screws. Hinges are still attached to door frame. The right person for the job will need tools to install handle assembly, possibly plane width of door in places im not sure. But heigjt should be fine. Also attach door to hinges correctly.

Hi Air Taskers I would like the following task to be undertaken: 1. Remove existing tv mount bracket and install new tv bracket mount (I will supply) to wall into wooden battens as per photo. Hang tv. 2. Hang round mirror. Supply wall screw to hang. Stud wall. 3. Hang 5 no pictures. Supply wall screw to hang. Stud wall. See photos. Any questions please ask. Would like to be undertaken on Sunday 27th October after midday. Regards Omar

It seems our door closing unit was installed wrong and therefore the door isn't sealing / closing properly. Need a handyman to turn it around and ensure it closes properly

I have a tiny shelf to be installed for my downstairs bathroom. It needs to be installed into the tiles and I don't have the proper drill and confidence to do this myself. Shelf is only 20cmW and comes with wall plugs an screws. Has fittings already inserted into the back only need 2 screws to be put on wall (straight) to line up with existing holes in back of shelf. Slots down on screws - very simple job.

Hi Air Taskers I’m moving into a new apartment and would like assistance with the following: 1. Hanging up picture frames to stud wall including supply of hooks and necessary tools (up to 4 pictures) 2. Installing my combined washer/dryer - connecting to pipe work with necessary tools Thanks Omar

Downstairs bathroom - VJ panelling on wall. We only need the panelling above the tiles to the ceiling. Measurements: 2300x800 height 2200x 800 height 1350x 120 height 1460 x 800 height

Need switch replaced for awning. Switch is removed. Will need to source new switch and install and I understand the cost of the switch will be additional.

I need gyprocker replaced 2000x1500 x2 on large wall x2 cut outs set and sanded then paint whole wall mirrors have been put on either side of the TV and I have to remove them and damage behind mirrors when I remove them only need to be patched but worst-case replaced Chiprock. I will send through photos of the mirrors that were placed next to ton either side. So there are two mirror that I put up on wall about 2.1x1.4 (x2) and when I take them down the wall is going to be ruined as l used liquid nails so either replace the gyprock behind it and and set and sand plus paint Wall is 7mx2.7

Drawer rail has come out of joinery. Rail needs to be fixed so drawer can go back in

20 (total) x corflute material signs to be installed on telegraphs poles & public fencing There is no particular poles or places i want these signs installed - just use your head. Anywhere that is going to stand out. Signs to be installed on main roads & back streets. All signs on poles must be fixed at a height people aren't going to rip down (maybe a few steps up the ladder). I will supply the screws & cable ties. To be randomly installed anywhere around the Shire in visible places on roads with good traffic flow and back streets but not blocking or interfering with traffic signs or street signs. Photo/location needs to be recorded of each sign install. Pay is $7 per sign installed + a tip for the right person Need to be able to meet up this Tuesday around Cronulla area to collect goods