Find an experienced handyman in Bossley Park

The resistance on My freemotion 370R recumbant exercise bike isn't working

Installation of LED light mirror and two towel racks in bathroom. All pieces are purchased and ready for install

Replacing two ceiling fans and install a large light round Chandelier in a dining room and 2 small light Chandelier over a kitchen island. You need to run the cables and make 2 separate switches 1 for large chandelier and 1 for both small chandeliers - see pictures. The fans you just need to place old with new with remote control. Old vans were operating on remote control. Double story home.

the removal of tiles and timber from under the house. It will require crawling under the house. I know it can be done. The electrician crawled under there. But I get claustrophobic.

Bathroom mud. I want someone that can remove and put new silicon for two bathroom.

Install 700mm x 900mm LED mirror in bathroom. Install towel rack x2

Install bathroom cabinet

Need 2 Ozroll motors replaced in my roller shutters

Roller blinds have fallen off the wall and need to be re-attached. One of the holders also needs to be removed before the blinds can be fitted back on the wall.

5 doors and frame fixing and paint

Convert manual roller shutter to a motor one

Need 1 door bottom cut of holow doors and installed in 1 bathroom. Need toliet roll holder , hand towel rack, towel hook,reno.

Replace 2 doors Replace toilet seat and seal Replace architraves about 10lm Install mirror Fix wall damage and repaint Replace floor board

Removal of silicon in shower that has mould and replace with new.

Someone to repair the blinds as pictured. Have replacements if needed. The original person who installed basically ghosted. Thanks

I would like to fix my window frames (as picture attached) and it's sinked a bit in the middle. My house has 2 storages and the windows are on the second floors.

I have an old sensors which are not working. I need someone to pull out the old and install a new one

Need 2x core holes drilled in concrete I already drilled two of them, but my drill has failed. I have the core bit, just need someone with a power drill to attach the core bit and make the holes. Plain driveway, slab is about 100mm thick, core hole is around 95mm diameter.

I need timberframework and gy rock instalment done , I will be supplying all materials.

Hi I am looking for someone to build a brick wall and render so we can install signage on it (letters etc). Dimensions would be 2 to 3 meters wide and approximately 1.8 meters high. Looking for a quote including all material, equipment, etc. Example of the signage we want to achieve and put on the wall attached. I've also attached the photo of the site with the "wall" drawn in red. Any question let me know - we're not in a hurry, want to make sure we do this right. Thanks Lisa