Find an experienced handyman in Mount Cotton

2 bedroom granny flat, walls, ceiling plastered and villaboard in wet areas need doing

Quotes only "Sliding security door needs adjusting to close smoothly"

Hi, We need a handyman to wall mount a tv, hang a clothes line and a large metal port hole.

Need to move the washing line up. Just need someone with a hammer drill as I don’t have one. Could use existing bolts but my need some plugs to put into the bricks so the screws hold.

Refer to nail images attached

I need two power points installed in house and four down lights in pack patio (wiring already installed in patio)

I am looking for someone to hang a dryer for me. I have the bracket already.

I have two niche on a wall that I would like to fill in

Won’t turn on, no standby light.

Repair and patch the base of a back pack

Pet door installed into glass sliding door

Two sheds of size 3300(W)x5950(H)x2600(H). Come as two kits. Got installation video to follow. With flooring, roof and ceiling.

Task is to phone around and find me an identical laundry sink replacement. Item needs to be in stock and ready for collection by 3pm tomorrow. Measurements from edge of lip are as follows: 600mm long 500mm wide 250mm deep Stainless steel construction Sink must have holes for mixer and pipe placement. Task price is based on 2 hours work. $45 per hour. If you find one and willing to collect and deliver, additional $100 will be added to task price.

Handyman required for a few odds and ends eg: replacing toilet roll/hand towel holders (needs spring toggles), cut and replace end panels to outdoor cabinetry (easy access), replace a couple of light bulbs, trim one side of kichen cupboard by a cm to allow for correct sink bowl placement. Attach support to back of sink cupboard to allow for plumbing to be affixed. Must have all required tools (incl. table saw) and have experience in above.Apx 5hrs of work. $70 per hour.

Kitchen cabinet door hinges broken

The window frames outside the windows over the lounge room need to be replaced. Pls come on site to give a quote. The price I give here is neither a final price nor indicative of the real cost.

Hi Bradley, I need some fly screen mesh replaced om some security grills that are high off the ground. Need done by end of next weekend. Is this something you can help with. If so, could you ease quote on the job. Thanks

Hi Alex I need my front entry door shaved on the bottom and on one side to prevent rubbing. Is this something you could do quickly? Thanks

I need the digitizer screen replaced which sits on top of the LCD unit in my Lexus IS250, 2008. This is a common fault in this model. The whole LCD unit needs to be taken out of the console to do the repair. About 2-4h labor depends on experience. I have the digitizer screen already.

Trim the bottom of a door to fit the new carpet