Hire a trusted ignition systems repair service in VIC

ba ford ute ignition barrel replacement. needs a new barrel.

Key won’t turn in my car ignition barrel…. Had problem once before and a new key was cut… now same problem

My car key won’t turn in the ignition barrel

Bike shorted out when ignition replaced currently not getting any power.

Just had a new key cut ignition worked fine for half a day and now none of the lights come on the dash when I turn the key except for the little red lock light key turns all the way no problem

I have a replacement ignition barrel for my motorbike. The headlight needs to be taken off and then the ignition barrel unscrewed and replaced. A mechanic can do it in about 30 minutes or less.

Starter and battery are strong but the car is occasionally not firing up. I reckon 95% it is the wire in the photo that seems to have gone on an oily adventure. If someone of an autoelectric bent could fix it up that would be great :)

My bike seems to have no power to the ignition I have recharged the battery

Hello I need someone with experience with my ignition barrel on my 2008 Ford Territory. What’s happened is I put the key in the ignition, turn the key but instead of the spring resisting when passing the on to the engine start function it just completely turns to the top and absolutely nothing happens to the car power or ignition. It doesn’t start, it doesn’t make noise and there is no resistance. I need someone to have a look and help me fix it as cheap as possible. My kids are relying on me to get them to school and daycare come Monday and I’m freaking out.

Need ignition switch replaced on BF Falcon, 2006. Barrel is fine. Common problem with these Fords. Unreliable starting and won't flick back after starting.

Motorcycles ignition no go battery charged rectifier looks a bit rough ..rusty ,have a new one I brought .I was told by a online mechanic that it might be a common cause in Yamaha xvs

Labour for fitting 3 new sparkplugs and 3 Ignition Coils on a Toyota Aurion 2007. I have the parts but don't have the tools to do the change. I have already done Coils and plugs for 2, 4 and 6, so no need to take off the intake manifold. This job should take no more than 30mins. It is for coils and plugs on 1, 3 and 5

The battery is ok, Sparkplug are ok, apparently most be the starter

My car is the syndal tran station. The car is kia rio 2006

I have recovered my stolen vehicle and now in the processnof getting the car back together. I have been having issues removing the key barrel as the crook used a screw driver to start my car. The bolts are sheered and need to jimmy it out to replace.

1986 Mazda 929 Turbo, seems to be arcing out from the leads on anything it can, I just want it diagnosed, I do happen to have new leads, plugs and coil available here for it(specifically for the 929 turbo, not eBay)depending on price maybe it is just a case of having them fitted. It’d been a progressive problem that just seems to have gotten worse. I do have reason to believe maybe a plug is stuffed as I did find one not even hand tight, or maybe the leads as they are unknown and not the best. The coil is quite old, an I haven’t checked to see if it’s just an earthing problem from the battery or coil. I don’t have the tools, an I honestly don’t know mechanicals.

I need someone that knows what they r doing. Had bad experiences in the past. It’s a Holden Cruz Equip 2015 JH series

Replace ignition barrel on Nissan Pulsar 1993

Ignition switch wired up for engine start.Falcon XW GT

I need someone to supply and install ignition leads on a vy commordoore asap today iv changed the spark plugs but little bit has broken on the leads