Find experienced insulation contractors in NSW

Hi! I need a skilled Tasker to help update the insulation in my home. The job is split into two parts: Part 1: Crawlspace Above Flat Ceiling (Approx. 60 sqm) - Remove and bag old ceiling batts - Vacuum roof space to remove debris - Seal any gaps for vermin-proofing - Supply and install new ceiling batts - Dispose of old insulation at the tip - Timing is critical: Access is much easier during roof replacement. Part 2: Cathedral Ceiling Below Rafters (Approx. 65 sqm) - Check for existing insulation (likely none) - Inspect downlight ratings and install insulation as needed - Seal any gaps for vermin-proofing - Supply and install new ceiling batts - Timing is critical: Only accessible during roof replacement. Details: - Total roof space: 125 sqm - Roof replacement scheduled within 1-3 weeks, weather permitting - BYO industrial vacuum and PPE - Tip fees for disposal and insulation material will be paid for separately. Important: - Timing is crucial due to limited access. Work must be planned around the roof replacement schedule. Requirements for Tasker: - Experience with ceiling insulation and roof work preferred - Must have industrial vacuum and appropriate PPE - Supply of insulation materials - Ability to work safely in roof spaces - Willing to dispose of old insulation at the tip

I need internal walls and ceiling between floors to be insulated by preferably R3.0 insulation . Total around 375 squares mt need to be covered with insulation

Details: - Vaccum and dispose of dust of approximately 8m x 9m of attic. No existing insulation is there, just dust and pollen from London Plane Tree. - Lay R4HD Knauf Earthwool ceiling batts - https://tinyurl.com/7en9s5rp (these ones are dense so are easier to cut than standard Glasswool batts) - From my calculation of 72m2, the cost of the above insulation batts are $1640. - Steep roof pitch so plenty of clearance. NOTE: This task requires someone with the proper tools like an industrial vaccum and PPE.

Hi, Need to do roof insulation for the house. Requesting to visit and provide the quote.

Hello, we'd like to insulate the underfloor of an external bedroom, which is on a slope, so the access on one side is about 80-90cm, but one side is about 20-30cm (see photos). The surface is approximately 10sqm. The floor is timber, we don't mind foam or batts.

We have pink bats that need instillation in a celing tiled roof. Approx 216 squ metres.

Install underfloor friction fit batts plus strapping to approx 25m2 area. Tight area/Low clearance - 40-50cm. See photos for area to be completed and photo of part already done. Batts/Strapping/Stapler provided.

Looking for a skilled tiler, carpenter, or all-round handyman to assist with cutting and fitting Alucabond panels, aluminium strips, and installing Earthwool and EPS insulation panels. The job focuses on internal cladding for our promotional trailer. Requirements: Experience with Alucabond panel cutting and fitting Knowledge of insulation materials and cladding installation Attention to detail for precise cutting and alignment Basic carpentry or tiling skills preferred Dates: Start on Wednesday 06 Nov , continue Thursday/Friday 07-08 Nov if available Location: Glenorie NSW Pay: Competitive day rate + travel expenses Duration: 1 day (potential opportunity for additional work if needed)

I just recently found out that my ceiling is not fully insulated. It is a duplex, so ceiling space is not too big. I bought 12 pieces of the insulation batts which needs to be installed. Available Mon-Thurs. 8.30am-4.00pm.

Was going to do it myself but I’ve hurt my back… I’ve already bought the ceiling batts and have those plus the plastic bags & new PPE on site. The job is to remove the old ceiling batts & bag them, vacuum the roof well & put the new ceiling batts in. The roof space is around 70 sqm. BYO industrial vac or I can hire one. I’m also happy to help pass you the batts while you’re in the roof. I can take it all to the tip. Pls let me know if you’ll be bringing the vac or not. I’ve added a photo of the roof space as well as the ceiling batts. Thank you! :)

3 bedroom queenslander has no roof insulation. Side of house roof faces north, and contains solar panels. House is probably 70 years old. Roof space runs length of house. The tin roof is pitched.

Instal approximately 75 square metres of underfloor insulation. All space is easily accessible. I have staple gun required for instal.

Removing some still panels from the roof,inserting insulatio,labor only

I am looking for someone to put up insulation into the garage ceiling. I have the insulation batts and it requires little skill. Suppled- 1metre x 1metre platform ladder with safety surrounds to roof- totally safe. Staple gun, mask. It will take probably 3-4 hours.

Place insulation batts in roof cavity over existing batts. Batts supplied. 30 square meters. 5 hour job. Previous knowledge needed.

Need to sound insulate a room where my son play drum and Oboe

Area is approximately 8 metres by 8 metres to cover timber framing & install insulation within same. As much or as little as your time permits you to do. Any assistance appreciated by someone who knows what they are doing will be considered.

Installing insulation butts to garage still roof,labor only

I would like someone to come and assemble x2 kids bunk beds

The insulation above my 2nd bedroom is apparently patchy and in need of a top up (or replace, you're the expert, not me). There's maybe 2 feet of headroom, the room is around 3 x 4m. Happy to take your advice on approach. Often work from home so week days or weekends are on the table for completion.