Find a professional internal door contractor in Inner South Melbourne

3 x internal doors do not close, strike plate needs re-adjusting

Hang an internal door. Have hinges.

White double French internal door ideally with glass to allow light through. The frame already exists.

There are two internal doors where the door latches do not engage and need to be reset.

I have 7 internal doors in my house I'd like to replace all the door handles. It would require drilling new holes as the old ones are at ~1600mm high and would like these new ones at 1050mm. Would then need the existing holes patched and sanded back in readiness for painting. I will remove all existing door hardware and there is no need for any paint repairs to patchwork. I've attached photos including an example of the patching required and what the internal doors currently look like. Also included the new handles for install.

Toilet door currently swings inward, needs to be replaced opening outwards. Hose reel and lock to be drilled into external brick work . Heavy mirror to wall

Looking for a handyman to install a internal door handle (bathroom) (supplied) as well as fix up some holes in plaster (small)(we have the paint) but don't have the plaster

Replace 2 internal doors with NEW doors. Doors/Hardware will be supplied by myself

Hi there, Looking for a handy man to come and hang an internal door for us. It’s a very basic door for the bathroom. Nothing special. Many thanks, Laura.

internal door hole patch

one internal door is in bad condition and needs to be replaced hopefully with another existing door in the house

Internal door hung on existing hinges and fit new handle New door at location and will need some trimming.

Replace small broken glass in the internal door. The inside glass measurements ( may not be 100%) Width 595mm Height 365mm From top corner to bottom corner 690mm Touch up paint if needed

I have just provided this

New carpet means bottom of bedroom room is rubbing on carpet and wearing. Door will need to be taken off, taken to garage and have 5-7mm planed off the bottom. Easy task for someone with the skills and tools

Internal door hung to replace old one, the screws holding the hinges are busted so will need to be offset slightly I’ll supply new door, need it delivered as it doesnt fit in my car. No painting necessary and original handle

Opening for the door is 80cm wide by 202cm high Already has hinges on the opening Just after a plain white door And delivered to St Kilda East

Opening for the door is 80cm wide by 202cm high Already has hinges on the opening Just after a plain white door

Remove door and architrave. Add stud frame in opening. Add 13mm plaster both sides. Add lower bull nose skirting both sides. Fill sand and paint wall both sides. Wall about m wide. Colour Grand Piano 1/4 strength. Remove all rubbish.

Install cat door in hollow internal door.