Find a trusted local mechanic in Slacks Creek

Need Mobile aircon regas on car is r134a complaint.

Rear pads / roters need replacing on Nissan Qashqai 15

Really would like to get my cars regassed asap if anyone can help out with that. Even a recommendation would be fine can't for the life of me find anything - Due date: Flexible

Fit bull bar to mn triton have everything nuts bolts brackets tjmbar came off a mn triton - Due date: Flexible

I have a Turtle in a 4 m tank at my Factory. The pump/filter is about 2 years old and has stopped working. It is a quality pump and I turned it off to clean the tank but when I turned it on the pump did not start. - Due date: Flexible

just need them to take of my old brake pads and fit new brake pads . i have brought the new brake pads and brake fluid - Due date: Flexible

Mazda CX-7 2008. Was running fine until I switched from auto to manual on highway as it struggled to go over 3000rpm, kept switching to 5th gear going 60km on normal roads and would go to 6th gear on motor way up to 100km but then switch down to 5 and back up to 6 if going over 100km/hr. Other than that it was running fine. Anyways, I switched to manual mode and was switching down gears exiting motorway, before i got to first gear at a stop sign it suddenly switched itself to first gear and then started jerking all the way to a friends (about 2km’s). Once i got there i put it in park and it continued accelerating even with my feet off the pedals. I turned off and on again same problem. I managed to drive another 40mins home, was fine once past first gear. But then went to use it today and it stalled at the lights. Got home still with jerking in all gears. Checked fluids, and connections seems to be ok. Negative terminal has a little corrosion and if you listen closely there is a very quiet click sounds like battery attempting to spark (while car is on). Can also hear the fuel pump running. Reset the CPU with the old disconnect battery trick, problem still there and now all engine lights on. TCS, Skid, Engine, oil, and battery. I tried to take photos of back of engine where 02 sensors, cat, alt are… not sure if its alternator failing or possibly acceleration pedal sensor. Online seems to suggest upstream 02 sensor or MAF. Just need a mechanic to come take a look run a scan tool for codes and give experienced advice. Thank you - Due date: Before Monday, 20 March 2023

After a qualified mechanic only to do a service on a 2003 Holden Caprice. I have all the part's leads,plugs,filter's,oil etc. Also need the brake pads done which I also have as well. All parts are new!

We are currently looking for a casual or subcontractor qualified mechanic. - Due date: Flexible

EDIT: MK Mitsubishi Triton 2005 GLS V6 petrol 4WD requires rocker cover gasket replaced, spark plugs, rear shock absorbers changed. All parts supplied. Flexible with timing. Require reverse thread drill bits for two stuck bolts. - Due date: Flexible

Looking for someone (experienced) to change front brake pads on a Honda CRV (2001). Will need to be able to complete either Wednesday or Thursday in Slacks Creek. Brake pads supplied.

Car won't start. Lights radio on. Battery and oil light displayed. Tried to charge battery. No start. Under bonnet oil leakage from spark plug area. Cleaned surface oil. Possibly need get to main spark plugs clean oil and replace sparks plugs for Mitsubishi magna. Have asked for quote for spark plugs from Autosave. Would like to learn and assist. Further honest inspection welcomed. Parked outside shopping area. Day negotiable due to rain. Preferred date this week 9 to 13 May. Need car for work. thanks. - Due date: Before Wednesday, 11 May 2022

Need someone with the tools and knowledge to remove and install a diesel injector pump on my 2006 turbo diesel ford courier already have the injector pump

I have two 7 inch light bars that I want installed on my roof rack and all wires up.

Looking for old school car mechanic to maintain, repair, upgrade classic car collection . Possibly suit semi retired mechanic/engineer

Need a motorbike mechanic to come and diagnoseand and fix my 2012 kawasaki kx450f fuel injected. The bike will start but it take ages and stalls as soon as you turn high idle off then got to kick it over another 30+ times before it will start and smells real fuely