Find local NBN electricians in Canberra

Recently obtained new modem to connect to NBN network. The DSL cable is not connecting to internet. Not sure outlet works as I have never used it. DSL wall outlet needs to be inspected and rewired to enable ethernet connection to work and connect to modem.

Our NBN is located outside in a box we cannot access fully , would need the lid either cut or removed to get to the NBN . Would then need help setting up as have instructions from service provider

Need new NBN cable installed. Existing cable is faulty/damaged.

Need to have a 8-10m conduit pathway with a drawstring to provision/enable NBN tech to pull through fibre from NBN Utility box to interior connection location. Interior Roof access is simple and comfortable and almost straight run. See pictures - conduit and string from outdoor roof eave through to comms cupboard in centre of house. Following exisiting comms wiring entry point already in cupboard.

I’m looking for a NBN electrician to relocate my NBN internal box from the living room to the garage. The current locations of both the internal box and the external NBN box, as well as the desired new location for the internal box, are clearly marked in the attached photos. The connection from the NBN external box runs through the roof, which is accessible for a person to enter. The house is a wooden structure with plasterboard walls. Additionally, if possible, I’d like to install a new network wall socket at the current internal box location after the relocation. However, this is not included in the initial quote, as I’d like to decide based on the situation. Please let me know your availability. Thank you!

I have a FTTN nbn connection at my house. Currently it terminates in an inconvenient room. I would like you to move it to a different room. The house is old double brick. The cable can poke through the ceiling in the new room and run down the wall to a socket (conduit and socket must be supplied by tasker). Expect a clean looking finished end result in the original room and newly wired room.

Hi all I live in quite a new property and my nbn box is on an outside wall. There’s 5 data points/sockets throughout the house, but I was only able to set up the router outside in the metal box. Was hoping for someone tech savvy to sort out the wires (if possible) to be able to have the router inside in one of the data points. I do have a booster mesh network set up but am hoping to improve my internet strength by bringing it all inside. As I moved my provider didn’t come and install and I’m clueless!

My current internet provider has advised we have a bridge tap which is impacting our ability to reach higher speeds. Would like a quote on how much it would be to identify if there is a bridge tap and remove it.

i need the nbn box relocated

NBN Bridge tap removal in an apartment.

Install LAN Cat-6 cable from garage NBN router box to 1st floor rumpus/media room . The house is 7 year old and is double stored

Looking for electrician with the fibre optic cutters or crimp tool to relocate box lower like the second picture. First picture is of how it’s like now

Relocate NBN box from one section of house to rear

Remove or Relocate NBN UPS inside house.

I need a conduit installed from the nbn box on external wall to an interior cavity wall. I also need some coax and aerial work in ceiling.

We have not purchased a battery replacement yet

Looking for an 'off duty' NBN tech to help me pull data cable through underground conduit. 1. I am FTTN with an existing above ground connection 2. I recently went underground with mains power, so whilst we were doing that I got my sparky to run conduit at ~300-400mm+ deep (It varies across the length of the trench) suitable for NBN cable from the pole to the house. There is about 23m of conduit with a cord already fed through and taped off at both end. The conduit has no sharp turns, it's a straight run except for some gradual bends up at either end (sparky did the lot and knew what he was doing, says he does them all the time). 3. The conduit terminates a few feet above the ground, so we may need to connect another 1-2 lengths to properly house the cable once pulled. I am seeking a way around NBNs absurd '$500 simply to quote' process, and do a direct cash job with a tech who knows what they are doing in this space. Airtasker price is nominal at this point, seeking to discuss further with someone to arrive at a fair price. P.S. - I would be seeking you to also provide the cable, or tell me what/where to buy and I can get it myself. EDIT: I want the cable to actually be connected on both ends so my connection with ISP can be reestablished (although happy to complete that task with them if for some reason the change in cable triggers somethin to be done on their end)

I have been informed by IInet my connection for wifi is being impacted by a bridge tap. Do you have experience in this?

I need to put up new NBN socket for FTTP from underfloor of the house. - Due date: Flexible

NBN-FTTP has just been installed, but nowhere near the existing router. Have pulled a Cat6 cable from the Router to the roof space above the NTD. Need someone to drop the cable through the cavity next to the NTD and terminate - Due date: Flexible