Find a professional patio contractor in QLD

I am looking to enclose a small section of my patio (3mx1.5). Half will be enclosed with timber and the top half will be screened.

I need to raise my patio floor, can use yellow tongue for the floor surface, details as below: Width - 6.4M Length - 2.85M Height - 90-95MM You're to install and supply all required materials for the job.

Hello, I'm seeking someone skilled to construct an angled slatted privacy wall (similar to the images shown). It will run approx. 2800 long. Happy to source materials (wood), or for it to be supplied as part of the job.

Attached to house, posts bolted to concrete a direct replace for the current one which will be removed prior.

Outdoor patio roof has metal panels as well as two polycarbonate panels. The two polycarbonate panels are approx 15 years old and need replacing (one is badly cracked). Screws on polycarbonates also need replacing as dome seals have corroded over time. Materials supplied by me (or you supply and add cost onto your fee) Happy for quotes

Build a small patio over a concrete pad 1.4 x 3.8

Need to install a patio and happy for suggestions

Installer need to come measure and give no obligation quote this should include all material (include compsite deck)

Repair patio ceiling lining The carpenter must be QLD licenced and experienced in this type of work. Description as per my building inspector's report: The upper end of the patio roof has not been fitted with a weather flashing and moisture has been leaking through the open ends of the roof sheeting. Wood decay has damaged sections of the framing and the timber battens to the patio ceiling lining. A metal weather flashing needs to be installed. Sections of the patio ceiling lining and timber battens need repairing and re-securing. A licensed carpentry contractor should be consulted for rectification options and costs.

Need a basic Patio approximately 6x3 m built down the side of house, attached to house. Happy to discuss budget in person

Looking for someone to make the attached photo of a corner patio. One side would be 4.9m and the other 4.2m.

I wood like to enclose my patio area, I have 10 mtres of very good quality shade cloth .. also some hooks put up... House is made of bessa blocks n timber...

Hi bud saw your offer on someone’s task thought I’d ask if you could give me a quote on patio repair

Looking to get a done a timber deck for small outdoor area. See images for dimensions.

I am looking to have patio on both sides of back of my house. Looking for someone who can professionally install Stratco or similar quality product and carries appropriate license and insurances for workmanship Also both side gates of house to be sourced and installed from stratco or similar

Looking for a rough quote to build a patio roof over our deck, see photo. Roughly 6x9.5m (off the house to the pool) Then around the side of the alfresco which is roughly 1.5m x 6m Newport 4020

Remove patio doors and replace with a pair of French doors. The doors are pre-owned and I have the original frame. Space slightly larger than doors and frame but happy for packing out 10cm on each side width. Vertical space of doors and frame is fine. I’ve no idea what amount to offer so please bear that in mind when considering interest in my task as you’ll need to give a quote on inspection onsite. Thanks.

New footpath and patio options required. Options could be: composite decking, timber, concrete, etc

Supply and install the decking for a Patio (3.76m x 3.56 m - as shown in photo ). Prefer low-maintenance material such as composite or Merbau. Please outline your offer and experience with a couple of photos of your past work for reference.

We need an experienced professional to install composite decking on our approximately 36 square meter outdoor patio. -We’ll provide all the materials. -What we need: installation, labour, and tools.