Find professional picket fencing services in NSW

Need about 20 starpickets installed. And an extra set of hands to put a portable roundyard together. Should only take an hour or two. Over the next couple days would be good. Between 12:30 and 3:30

I am looking to have a picket fence at the front of our property at Oatley. See attached images for approx dimensions and picket style we are after. Gate overall gap is about 1550mm but we are hoping for a gate approx 1000mm wide with visible timber posts either side to bridge the gap (similar to the attached). Wanting the gate to open out and to the right. Want the height of the gate to be approx 1100 high.

Remove and dispose of existing fence. Build new fence 17.5m long. 1800mm high at bottom of drive. 1200 at top of drive. Looking for a fence that looks good on both sides. Ideally a picket fence but will consider colour bond.

Replace or restore picket fence

Put a fence up about 9m, have all bits, you just need to bring you cordless drill and drill bit.

remove and replace bent and broken fence pickets approximate 20 -25 pieces . We will supply the fencing and dispose of the rubbish. a few panels at front of house would need to be sawed at a angle as shown by the 1st picture.

Replace 3 existing picket side gates with similar gates. Also need side lattice changed on 2 of the gates as well.

Build two white picket fence along retaining walls in two gardens. Please see map for location of the fence. Total fence length required is approx 27m. We need a 1m high white picket fence along retaining walls in both our front and back gardens. See photos for the style of fence. Dimensions are front garden (pictured): Front fence: 13.8m One side fence only required: 2.75m Gate required for the side fence: 0.9 m Dimensions are back garden: Front fence: 9m Side fence (one only needed): 1.3m No gate needed. Both have a retaining wall of sandstone and wood. The fences are on a sloping block, so care must be taken about heights. All materials to be supplied.

Fence had wrong wood on the horizontal beams. Needs repairing and or replacing Painted also.

Damage gate with Pickett fence

Looking for someone to supply/install a 29.4m Picket Fence in the below style for picket design and spacing. 1.2m high with 2x 900mm gates.

Remove old picket fence including disposing of materials and build a similar picket fence including gate with materials to be supplied by you. Total length is approximately 9m (fence of circa 8m and gate of circa 1m). Height is currently 1.1m and looking for the replacement to be of a similar height or slightly lower. Also a small front side fence area that is 3m long to potentially be replaced; although that may be repairable. Photo is from street view; fence is more dilapidated.

Essentially I just require someone to saw a piece of the gate off and attach hinges and a lock, to that piece, so that it turns into a gate opening.

Replace wobbly gate post, gate latch and some picket. Then paint fence and gate. Materials will need to be provided.

We need to build 8 metres of picket wooden fence to match existing front fence. This part of the fence was brick fence before. We had removed brick and need to build wooden picket fence to replace it. The sizes: Posts: 90x90x1100. Pickets: 70x20x900. Rails: 45x70

Picket fence at the front of the house

Installation of Picket Fence for front garden,install set of double gates for vehicle access. 1 single gate approx 1200 wide. The total length is just shy of 17m. Posts will need to be set in quick set, then notched to carry the horizontal rails. Pickets then fixed to the rails. All materials will be supplied.

Will post photos in the morning ..

Need front fence with sliding gate 15mt along frontage 5 meters down one side

Install 30 pocket stakes Picket post driver available on site. Preferably tomorrow or Wednesday morning.