Find professional picket fencing services in QLD

See pic for reference. Add single post immediately to right of driveway and add new section of picket fence (approx three metres) between this new post and existing post on fence line between ours and neighbour’s yards (there was previously a fence here; the end post was not removed and can be reused). Install at top of driveway a double gate (approx 3 metres) with latch. Nothing extravagant, can custom-build if you prefer. Picket palings on gate to match fence. Existing palings in picture will already be removed so their removal and disposal is not part of the job. Paint existing fence rails white. Supply and install new inexpensive 1.2m high palings across entire front (fences and gate - approx 15 metres total). Existing gap left for entry via steps. All existing and new rails, posts and palings to be painted white, both interior and exterior facing.

Fixing and installing star picket and wire fencing on an average property in Brookfield. Will pay on an hrly basis, $40/hour neg

Replace current timber picket fence, posts and gate (driveway and pedestrian). Paint in white. Frontage is 20m.

Replace a back wooden picket fence

100m star pickets and cyclone mesh fence.

Need the bottom of my fence closed off as my dogs are digging to get under there is gaps all along the fence.. have attached 1 photo of it that is just a section of it

Remove current fence palings and build picket fence

White Picket Fence: I wish to have someone help with a 1.2 metre picket fence. I have the timber posts and railings prepared and painted white. I have also prepared the sleepers, which have also been painted white. I have a good idea of where the posts will be placed, but I will need a stringline in position. I have purchased brackets for the railings and the sleepers. I will, most likely, put in the pickets myself once the posts and railings are in. I have 2 aluminium powder coated screens that need to be placed between two sets of posts squarely within the fence. These will add a decorative feature to the fence, and will be positioned in front/behind two trees. My intention is to place the posts in the ground without concrete (as this will extend the life of the timber), and connecting the posts with a sleeper at the bottom of each set of posts. I am open to concreting these?? The sleepers are pre-painted and will go into the ground slightly between the posts. There is mulch in the garden where I intend on planting native plants once the fence is completed. The fence is curved on a corner block and also slopes downwards on one side. I plan for the railings to be placed parallel to the ground, so it slopes with the ground at an angle. The railings and sleepers will fit between the posts using the brackets and the pickets will be fitted to the railings and the sleepers which will be parallel to each other so the railings don't slope downwards over time. You will most likely need to inspect the property first. I also have an electric hole digger but it is quite narrow, but should be helpful . I can provide photos at a later stage or you can come and see the property. The pictures of the fence below are examples of the brackets. The painted timber is my own. Thanks, Wendy

Build a picket fence. No photos because we would like to have a discussion first about where and how big.

Approximately 80 mtrs straight line flat and clear

I have an old picket fence with gate ... 15 metres... needs to be replaced and painted.

I have an old picket fence that needs to be pulled down and replaced.

I would like my old picket fence in my pool area painted. The fence would be approx 30 metres in length and only about 1 metre high all around as per pictures.

New sheep paddock fencing build using star pickets, electric fencing and mesh. 100-150m worth of fence.

I have a side access area where there seems to be an existing panel of pool fencing that I need secured in place, possibly by driving a couple of star pickets in and then attaching the panel to those with wire? As a somewhat temporary measure but secure enough to secure my dog in the yard.

Looking for someone who can install a picket fence, for my front fence, including a gate. Willing to discuss price first. - Due date: Flexible

I need a white picket fence built to enclose this outdoor area. Approx 7.2m total, please see 'photo 1' for reference. There is an existing pool-like fence that will need to come out first. I don't have a great pic of it, but 'photo 2' gives you a pretty good idea of what it looks like. Please include the pool fence demo and removal from site in your quote. I'd like your recommendation on fence height. Something with a little privacy but still gets some sun, likely 1200-1500mm I'm thinking. I would also like advice on PVC or timber and painting if necessary. Unsure on the pricing here, I'm happy to negotiate. If you need any further info please let me know, thank you.

Large 800sm corner block needing a new timber picket fence. Approximately 70lm Hardwood posts and rail. Treated pine pickets. Front at 5ft and side at 6ft Looking for very neat craftsmanship.

- Front fence - 23m wide - colonial top picket fence with hard wood posts - 4 post arbour with gate - automatic driveway gate

Hammer in 18 star pickets for fenceline. Easy open paddock for access. Materials (pickets) supplied.