Find local power point installers in WA

I need a weather proof powerpoint install in external wall in Thornlie

We need to replace a light fixture that does not work. Replace a power point that has been removed and replace a loose power point

2 light switches 3 power points /2 socket 1 power point mover 30cm 2 light socket moved 30cm Over socket Dishwasher socket

Looking for an electrician to come and install an oven and couple of power points

Remove 2x security lights 1x PowerPoint 1x light fixture 1x aircon point Eaves are being removed and then will need to be replaced when eaves are reinstalled

Need a power point supply and install - to match the pictured one - I believe it is Clipsal with aluminium brushed plate cover , good access to roof via manhole close by

New power point in kitchen. And a two point converted to four

Installation of 3 new double power points

Install a double power point. Face plate is already in place

Can someone please install 3 double power points to my house?

- Outdoor, weather protected power point to be installed for 10 amp spa. Please bring your license with you for sighting

Power switch for electric stove has stopped switching on, I think its just the switch that needs repairing or possibly replacing

PowerPoint replacement it has stopped working Location coongan st Greenmount

Professional accredited electricians only. We require another power point in the garage on the side I park my car (internal wall) so I can charge my car. There is another power point on the inside of the house close by where I would like the power point on the other side of the wall in the garage - we are unsure if this helps the installation or causes complications. Power point must be suitable for EV charging (AC charging) but open to recommendations if you have other ideas that are suitable. We would also like another light installed in the garage where the internal door is, as the placement of the existing lights when the house was built 3 years ago was not done well. Ideally we’d like this hooked up to the same light switch we have now that turns the other 2 lights on/off. PLEASE provide a quote for both seperate jobs (power point installation + light) so we can assess whether we’d like to do both jobs or just the power point installation alone which is priority. Victoria Park 6100, flexible on time.

We currently have an old hardwired oven and are hoping to replace this with a new 10A plug/ lead oven. We dont need the old oven taken away, just need new power point/socket installed to rear of empty oven recess that will allow installation of a suitable new 10A plug oven when it arrives. New oven hasn't been purchased yet as we first want to determine whether conversion from mains wiring to 10A plug socket power for oven is easy/ possible to do or not. Note: please excuse the mouse poop shown in the photos, this was discovered when we pulled out the old oven and will be cleaned up before any electrical works take place.

Need to move PowerPoint about 15cm to the right so it fits in a new cupboard. Double brick wall. 2 story Town house. Please read screenshot in photos.

One outdoor power point install required. Indoor power point on exact other side. Single brick, single story house. Requires an RCD 30mA

Licensed electrician to install additional light and power points in a less than 2-year old house. Single-storey house Power and light fittings supplied by owner. 3 x new light points and 3 x power plates.

Looking to have 2 ceiling fans installed. One in the patio area and one in the living room. Also looking to get a new power point installed in the dining room.

Madimack InverEco 200 20.4kw recently installed but requires hardwiring. Sparky needed to come connect up. Power nearby but I believe needs its own circuit. Circuit board on opposite side of house and has room. Also have an external wall PowerPoint that needs to come down 500mm or so.