Find a professional render contractor in Inner West Sydney

Apologies new to this!! New all required to be built in bathroom. Approx 2400 x 600mm 100mm. FC sheeting to allow for final finish of micro-cement. Patch existing render which has been removed on the demo stage. In bathroom and small patches in ceiling. Plaster to ceiling where cornice was removed.

HI there. I need a brick wall and pillar cement rendered on one side and simply bag washed on the other. No painting required. Dimensions approx. 4m x 1.8m. See pics attached.

Need to cement render wall to hide imperfections The wall measures around 7m x 2.5m high with a window 4.2m x 2.1m and 3m x 2.5m on the otherside

Render repair required on upstairs window. See photos attached. Job is to repair render on all 4 sides of a single window and leave ready for painting. I initially thought that this job could be completed from inside, but I have not been able to remove both parts of the (sliding) window components. Therefore I now believe the job will need to be completed from the outside with a ladder. Good access from below pathway, however bidder to confirm that there is enough space for safe operation of their ladder.

Remove bathroom wall tiles and render walls ready for tiling

need 2 walls rendering approx 14m2 all materials on site render mesh fixed on walls need these 2 walls doing asap but have lots more internal rendering needed on this job in next few weeks

I have a small patch of wall, which previously had tiles, that I would like to be re-rendered smooth so that it can be painted. A small skirting board will the attached to hide the gap near the floor. This won’t need to be done by renderer.

Interior new arcylic render wall, sand and paint the wall. abont 25 sqm

Rendering brick wall with a few bricks required.

Fix my f**kup! Need this area under stairs rendered.

Repair brick wall and render

I have some patches of interior wall render that I would like matched to the existing render. The largest two areas (pictured) are approx 75x20cm and 20x20cm, the rest are much smaller patches. I can sand down my amateur attempts before arrival if that will save any time/cost. Let me know realistically how closely the render can be matched.

Render brick walls Approx 3.4m each side and 1.2m other side 85cm high

Wall in bedroom needs to be repaired, prepped and rendered, ready for painting. Wall has been damaged due to shower leak in bathroom next door. Wall has now been dried with main wet areas cut out and disposed of. Job does not require painting of wall.

Looking to get a rendered brick fence. Approximate length 11m, height 800m and columns about 1.2m.

repair of HEBEL render wall that has small/thin crack

- Render the three faces/sides of the alfresco slab to a natural stone finish - render colour: very light grey to match top surface colour as close as possible

- remove remnant brick fence 1.0m (L)x 0.5m (H) x 0.3m (D), leave neighbour's pillar alone - cut/remove any protruding bricks - render the entire side of the damaged pillar with cement to create a smooth/flat finish

We hired a sealer to come patch holes from recent electric and plumbing work. We did this so that we could repaint and with a fresh wall as we are installing new kitchen. I am pretty sure the work the tiler/sealer did is very poor and not up to scratch. (See photos) Unfortunately we are only adding a new kitchen because we discovered hidden water damage after purchasing our first apartment. The cabinets get put in Monday so we would need help tomorrow. I am 3 weeks from delivering my first baby so it’s all quite stressful. Please let me know the amount of work it would require to smooth this out. We feel a bit cheated as he said the work would smooth out everything and we could paint it all white for a blank canvas for our kitchen install and it’s left a huge mess for us to clean and figure out.

We are looking for a quote to render our external walls