Find a professional render contractor in NSW

Hi we need someone this afternoon to finish the render on rest of my low walls at front of our house. It's a small area at entrance please see photos of the left walls and right walls. As you can see in first two photos we started it Please see photos basically any exposed brick needs rendered as well as possible can. Not going over and sandstone Needs to be as best possible flat on top, and squared off/straight as best can. Can use metal angles etc Please quote exc materials thanks

Mesh and render a small patch (500x450mm), render must blend in with the existing surface

We need to Render wall that is approximately 50 m². Quote to include all materials required for the job.

Damaged retaining wall needs to be repaired + ideally painted. Need done by end of next week.

Please see photo I need the parapet section highlighted in red to be rendered preferably using foam 75mm however open to other ideas/products Furthermore 2-3 exterior walls to be rendered Let’s discuss Job ready to go

Fix chipped render 3 spots

We've removed some old timber from a wall, just under the roof line, and so we now need the area patched and rendered smooth to match the rest of the wall. The total area to do is roughly 3m x 20cm.

1) Looking to do small concrete ramps for front and side (sidewalk) (ramp)area rather that steps. see the photos 2) Front Poarch Entry way, repair to rendering/water damage??? 3) additional Concrete work in the near future.

Small area of render required to be removed and re-rendered (would prefer not patched) Area is circa 2.5sqm Please quote inclusive of materials and labour

10 to 15 metres long x 30cm area, front of slab. Smooth over with render the front of slab which is currently rough from tile screed being laid etc. The slab is on second story. It can be accessed from balcony as the glass has been removed.

I have two external wall at the front of the house would like to get it rendered. It is roughly about 6-7m2

Need concrete render repairs in several areas. One bad cracked area, and one wall where a wardrobe was removed and left several holes.

Looking for someone to patch rendered brick wall - just areas in red. Need to fill in bottom half of the intercom cut out as shown and the holes in red.

We need to render bricks at couple of point that are missing render to match existing external walls. See pictures for more details

I need assistance with installing multiple shelves and picture ledges in my apartment. The walls are rendered brick. Please see the details below: 1. Ikea Picture Ledges (55cm, qty 6): To be installed in the lounge room and hallway. Very light and not heavy. Note: Does not come with screws or wall plugs. Can you supply them? 2. Ikea Picture Ledges (115cm, qty 2): To be installed in the lounge room and bedroom. Very light and not heavy. Note: Does not come with screws or wall plugs. Can you supply them? 3. Bunnings Flexi Picture Shelf (90cm, qty 1): To be installed in the lounge room. Very light and not heavy. Comes with screws and fittings. 4. Bunnings Montgomery Floating Wall Shelves (qty 4): To be installed in the lounge room. Each shelf is light. Comes with all required fixings. Additional Information: - Photos: Photos of the walls and products are attached to provide clarity on the installation. - Location: Potts Point/Kings Cross area. - Parking: Street parking can be challenging but is possible. I will provide a temporary visitor permit that allows parking within the Kings Cross, Rushcutters Bay, and Woolloomooloo precincts. Requirements: - Experience in drilling and fixing items into rendered brick walls. - Ability to supply screws and wall plugs for the Ikea picture ledges. - Your own tools for installation. - Start time 07:30am Tuesday 17/12/24. Looking forward to hearing from you!

Damaged area of brick fence requires rendering and painting to be matching with surrounding area.

Would like the render removed on two internal walls in a bedroom. Shown in picture. I have a cold chisel and hammer but if you have an electric chisel that would be helpful. Looking to remove the render so that we can waterproof the brick work. Therefore just need to remove as much render across the two walls. Should be able to do it in a few hours

Our front wall is in need of repair. The current render has come away from the brickwork and so it needs stripping back. We would like to re-render it in a smooth render. It will need to be a water proof render. It would be great if we can get this done before Christmas if possible. The wall is approximately 1.5m height and there is about 3meters of wall (including the wrap around to the side) in length. Images to follow soon.

A low wall 6m long needs to be rendered on one side 600mm h8gh and the top 200mm wide. Easily accessible

I don’t have the tools, but simple quick job drilling 4 holes in wall and using supplies fitting to mount hose reel to wall.