Find a professional render contractor in Sydney Eastern Suburbs

2 story house in Dober heights needs to be skim coated. Apply coloured rock coat on top. Experience with product necessary. Scaffold is already up

I need a concrete block wall, and poured concrete steps, rendered to a smooth finish ready for painting. The total length is approx. 10m long and 1.1m high. You'll need to provide all tools and materials for the job.

Two areas of 320 x 250mm to be rendered on a balcony after low wall was removed.

Professional tilers only. Please render and tile small sealed fireplace. (Width 34 cm, height 58cm, depth 12 cm). The gaps have been filled with fila foam. All Tiles and white grout supplied (we have 12x sheets of tiles). Please see image of herringbone pattern. We do have villaboard, however expect that will be easier to render given shape. The floorboards in the front will not be tiled, and will be sanded back and polished at a separate time. The gas valve will still be accessible and visible post tiling. Will need to be tiled around.

Render approximately 20 square meters of outdoor walls. Use acrylic render

We took a shelf down and now the wall needs patching/rendering. Approx 3m x .1 wide refer photo

Render add on piers to match existing white textured render. Not sure if costing so I’ve put 123.

Need the wall cement rendered

Render wall over cable chase

Some cracks in the render on the outside walls of our house need to be fixed. There are a few areas.

Repair render inside (with similar textured finish to what is surrounding it). I will arrange painting. Also repair / fill outside wall around one side of meter box - note there is silicon sealant on the the edge so not sure if render will stick or whether silicon render required? I will paint this as well.

We require a renderer to render the walls of bathroom renovation please find photos attached. 16 m² total

Please make your offer on the price. We are completing a Bathroom renovation and we require a renderer and tilier. These may be different people but if in one this is preferred.

I have a 15x2 metre wall just built. It needs rendering. Straight wall - just one side

Apply Acrylic Render to roughly about 30 meters of walls below the awning. See attached pictures. Walls are 2.5 meters high. Should be an easy one.

Need a small hole rendered between the ceiling and the wall.

We need to have 5 sheets of gyprock, all about 1 metre high, fully set and rendered. This is on internal walls of our apartment, in two seperate areas.

I have an outdoor wall approximately 5 to 6 m long by 2.4 m high. It is brick and concrete. I want to have it rendered so that it is flat and uniform. I would also like to have a coat of waterproofing paint put along two joints before we render it. the wall itself is already waterproof, but just to be on the safe side. I would like to ensure that we give it another coat.

I have removed the tiles on my bathroom walls and need these walls to be rendered. I will be installing wet wall panels after the rendering has been completed.

Need someone to render low balcony wall where repairs been made. Need to blend in with the old sand cement render. Measurements are 560mm high and total approx. 3 meters long. Easy access through garage to the balcony.