Find an experienced retaining wall contractor in East Brisbane

Remove old wooden retaining wall and fence and install concrete sleeper retaining wall with colour bond fence.

Title: Architectural Drawings & Engineering for Retaining Wall and fencing (Up to 1.6m in parts) – Alexandra Hills I'm also applying for a shed to be built also. I may be able to get engireed plans from shed builder but some of your drawings may need to include the shed. It's 9m x 6m. Description: We need a qualified professional to prepare architectural drawings and engineering plans for a retaining wall up to 1.6m high in Alexandra Hills. The plans must meet local council requirements and be suitable for building approval. Must be certified engineer in Queensland Requirements: Experience in structural engineering and/or architectural design for retaining walls Knowledge of Redland City Council regulations Ability to provide certified engineering drawings Must be able to visit the site if necessary Please provide examples of previous work, your qualifications, and an estimated timeframe for completion. Let us know your availability and price. Thanks

I’m looking to get a quote for replacing my wooden fence, as it is quite old and damaged. Additionally, there is a 10m section of retaining wall (1.3–1.5m high) that also needs repair. The total fence length is 42.2m, and I’m considering either Colorbond or timber fencing. If you could provide quotes for both options, that would be perfect. Best regards, Eugene

We have a crack in our retaining wall which needs filling and then reinforced and re rendered

Repair existing 1m tall treated pine retaining wall. 4x 75mm thick upright posts to be replaced. 5 sections of wall (12 metres) need to be either replaced with new timber of have the existing wall replaced. The dirt behind will need to be dug away to allow for straightening the wall. The wall leans at 28 percent in the middle. The fence is attached to the wall and will need to be detached. Either a new fence needs to be built of the existing fence can be reassebled on the new wall.

Replace existing sleeper wall. Approx 1.2m x 9m

8 posts needs to be removed. Roughly 800mm-1000mm concreted in ground.

Build a 200 series block wall 7m x 2.4 All blocks onsite ready to lay.

Build a retaining wall approx 10m long and 800 mm high. Need to remove existing wooden wall.

Need two segments of timber retaining wall replaced. Each segment is 2200mm long and two sleepers high.

Need four X holes dug 600mm deep to take H supports for retaining wall see photos

Old taken down and new one erected

Removal of old retaining wall and replacement. Approx 21 metres in length and 60 cm high. Either cement or composite sleepers. There is side access for a small digger. Must be fully insured

Replacing retaining wall

Part of a retaining wall has collapsed following the rain event over the weekend - we need this repaired asap.

Part of our timber retaining wall has rotted and is falling away, concerned the soil behind and fence above may collapse, approx. 1.5-2m of repair needed, sleepers 3 high 50mm x 200mm

Need quotes to supply and build small concrete retaining wall. Length 10.2m. Lowest point 12cm Highest 38cm.

Thornlands area Hard wood posts Top cap Concrete retainer has brackets ready Garage is built to boundary so no access there. Also need a small side gate

Construct 8 metre long besa block retaining wall, 4 besa blocks high with existing wire fence on top.

3m x 1m High retaining wall - Post leaning. Needs removing of existing Post Unscrewing existing sleepers..Let soil fall (minimal) Replace post and re screw sleepers to posts