Find experienced local roofers in Camp Hill

Replace or repair corner section of gutter connected to PVC downpipe

Test 3x security sensor lights which are roof mounted (front of house and right side). We live in a two storey house, so you will need your own ladder. I’m unsure if the lights are working.

Need to replace approx 4m of Quad gutter. The section is above stairs as in picture. Will need trestle and plank.

Removal of exterior waterproof membrane on a retaining wall. Please see photos for reference. Approximately 5m2

I have a flyover patio awning and would like to stop any misty rain getting into the patio area. This will require some polycarbonate sheeting to be secured along the length of approx. 7300mm and depth from the bottom of the beam to top ridge of the roofing (obviously a bit more to allow to secure and off the top of the roof sheeting) of approx 150mm. The two end may need a brace and measurements are approx 800mm deep x approx 700 at front and approx 150mm + at rear to beam?

I have and 8m x 6m Bali hut for my lounge room. I need thatching taken off and steel roof replaced.

Jeep cherokee 2006 roof lining has come loose. Needing either repair of existing lining or replacement ceiling lining.

We are experiencing roof leaks along full length of the house (25m, half of the house is single storey and other half two storey), where the flat and angled sheets join, as per photo. We have tried to fix this issue with silicon and painted on membrane, but leaks persist. There is no access to under the roof as it’s flat, and also it can’t be inspected from the bottom as there’s insulation. I would like help from a roofer to identify and remedy the leaking issue. From my research it looks like maybe the flashing is missing and required to be installed all long the joint. I also understand that perhaps a full roof replacement will likely be needed in the coming years but am looking for ways to prolong the life of the roof at a reasonable cost. Ps, the roof has surface rust but appears solid for the most part. (Have included one photo of a rusty end in the laundry that I have managed to access. Please note this part and side of the house does not leak but does show significant, which I guess could be an indicator of other areas)

I need a couple of colourbond sheets replaced on my roof. I have a hole in colourbond sheet which has a temporary plug. - Due date: Flexible

Need your help to move 5 roof panel sheets from my front yard to back yard, roughly 20 meters away, through a sideway 1m wide. 3 sheets are 1m x 2.7m 2 sheets are 1m x 3.7m They are all 50mm thick with foam insulated in middle. Thanks - Due date: Flexible

Cut roof eave back fix roofing sheets re gutter - Due date: Flexible - Due date: Flexible

I have an empty wall socket (hole in the wall) and need to guide an electrical cable through the wall from the hole, into the roof cavity. However you cannot go straight up through the wall as there is a piece of timber running length ways inside the wall. This piece of timber however has large gaps at each end (it doesn't run the full length of the wall). So I need someone to use a camera to guide a cable up through the wall, around the timber and into the roof cavity. I have tried for some time with a cable fish unsuccessfully. I believe this is a job for someone with a camera. Access to the roof (manhole) is located in the same room. The gap in the wall (wall cavity) is roughly 45mm wide. I've attached photos for reference. Flexible on dates. No payment for having a crack, only if you get the cable run and I don't require the cable to be attached or connected to anything.

I need a cable run from the empty wall socket to the roof cavity. The access manhole is in the same room. There is currently no line/cable running there. The way up through the wall is impeded by two small pieces of timber which can be navigated around (they have clearance on the sides, however may require a small camera to do so. This job most likely requires a camera to guide a cable or attach a cable to lead it up into the roof. If you don't have such a piece of equipment I don't believe you'll be successful in the task. Payment only for completed tasks. Photos attached

Inspect the roof of a house prior to purchase. Further details: - Inspect for any damage or water ingress. - Inspect inside the ceiling if possible. - Provide me a report of the condition, and an approximate price to do any repairs. Roof details: - Double Storey - Corregated Iron - Approx 50sqm - Due date: Flexible

I have a asbestos roof. I had few leaks during 5 days rain event earlier in the year. However roof looks fine, doesn't have any issues. Size is around 12.5 x 6.6 Mtrs I believe Roof Restorations will cover most of the issues. - Due date: Flexible

I need some roof maintenance completed on a small section of roof. High set residence at Camp Hill. Extension ladder required.The following has been requested prior to an internal insurance repair being completed. We recommend the apron flashing which connects to the house weatherboard wall cladding is completely resealed to prevent water entering between the back of the flashing and theweatherboard cladding 2. To successfully seal the flashing we recommend the deteriorated sealant is removed from the top of the apron flashing and under the weatherboard. 3. We recommend the back of the flashing between the weatherboard and flashing is sealed in a continuous bead prior to re-securing the flashing against the weatherboard cladding 4. We recommend the resealed flashing is then over sealed at the top edge of the apron flashing against the weatherboard

I need a small section of roof re sealed with silicone prior to an internal insurance repair being completed. High set Queenslander located at Camp Hill. Full scope of works below -: We recommend the apron flashing which connects to the house weatherboard wall cladding is completely resealed to prevent water entering between the back of the flashing and theweatherboard cladding 2. To successfully seal the flashing we recommend the deteriorated sealant is removed from the top of the apron flashing and under the weatherboard. 3. We recommend the back of the flashing between the weatherboard and flashing is sealed in a continuous bead prior to re-securing the flashing against the weatherboard cladding 4. We recommend the resealed flashing is then over sealed at the top edge of the apron flashing against the weatherboard

Paint the underside of the roof sheeting and beams. It would most likely require 2 coats. Measurements are approx 4x12m. - Due date: Flexible

I need my roof cut back two roof tiles and a new fascia board installed. Only one side needs to be pared back (the overhang part)

Need someone to patch up a few holes on my roof ASAP