Find a professional floor screeder near you

MUST BE A EXPERIENCED CONCRETER

Screed full floor area shown. Waterproof all areas except the walk‑in robe. Tile full floor area. Tile bathroom walls floor to ceiling. Estimated total area for all tiling approx. 40 m². Contractor to supply all materials except tiles.

Looking for someone to repair and improve a small concrete ramp area at my garage entry. Scope of work: Clean and prepare existing surface Fill one side of the ramp flush (small gap area) Feather the opposite side smoothly into existing slab (no sharp edge or visible lip) Apply a light screed / skim coat over the ramp area to achieve a smooth, even finish Finish to a neat, consistent look (honed/smooth finish preferred, not rough patching) Area is small (approx 1–2 m²). Not looking for full epoxy system or heavy resurfacing at this stage — just a clean, level finish suitable for future coating if needed. Must have experience with: Concrete patching Feather edge finishing Light screed / skim coat work Photos attached. Location: Berwick Flexible with timing Looking for a tidy, professional result at reasonable cost.

Screeding a shower base. 900x1600 Offers please.

Renovating my bathroom this weekend. I will remove the old tiles and get all the walls and floor ready for tiling works to start Wednesday 29/4. I will Need the following: Shower screeded to falls. Waterproofing to floor and shower walls. Floor tiled with 600 x300 tiles. Full height wall tiling - 3 walls in 600x300 tile, one wall and nib (not built yet/shown in photo) in 100x100 feature tiles. Tiles grouted and internal corner siliconed. All materials provided.

Screed and tile my 65m2 house common areas only no bedrooms all materials already onsite

3 walls and floor to be screeded. Wall height 2.2 m floor space 1mx1m. Adhesive will be removed before job starts.

Need shower floor to be screeded, needs to be level with floor on the side and have a slight fall for drainage, it’s about 1.5 x 0.8m let me know if you have any questions Cheers!

Tile laundry area approximately 3x3

I need someone to screed the concrete for a water tank pad. It’s 2.8m x 0.8m I will supply all materials for the job and also I will supply someone to bring the concrete in wheelbarrow from the truck to pad location. You will just need to install concrete and make level that’s it. Will only take 2-3hours

Looking for someone to do bathroom tiling and cement screed (fall) work for a 2.2㎡ bathroom. Wall tiles: 1200 x 600 mm Floor tiles: 330 x 330 mm Tiles are already supplied. You will need to bring your own cement, sand, tile trim/edge finishing materials, and personal tools. As shown in the photos, waterproofing has already been completed. The job requires approximately half a day for the cement screed (fall/gradient) work, followed by one full day for tiling. Grouting and silicone finishing will be done by myself, so only the screed (fall) and tiling work are required. Please contact me if you’re available.

Current floor is 2 different levels. It needs to be levelled and screeded ready for tiles to go down

I need waterproofing and a screed shower done. If you can plaster as well let me know if not I will sort it out. The shower base wasn’t installed to AS and was taken out.

Tiling water proofing screeding

I need to remove the floor tiles and screed in the ensuite bathroom, 2.9m x 1.5m, only the floor tiles are needed to be removed, not the wall tiles. Everything is removed from The bathroom including toilet and shower screen for easy access and straight forward demolishing. I do have a chisel drill if needed

Need a experience concreator to level , trowel and screed for a pour

Screeding and tiling are required. I have a unit on the first floor, with easy access and parking. The existing tiles, shower screen and waterproofing, will be done on the 14th March. The screeding and tiling are required. The tiles are 200 x 200 mm, the shower is only 900 x 900 with 2 rows of tiles on each side being changed. We are after a licensed tradesman with insurance. Please contact for more information if required. Photos are before tiling is removed.

Supply and Installation of Semi-Bonded Screed MAXIMUM 80mm thickness (0-6m2) USED WHEN THICKNESS EXCEEDS 50mm *Supply and install semi-bonded sand and cement screed to build up floor height and achieve correct levels and falls to waste prior to tiling. *The screed is applied over the first layer of waterproofing membrane, forming a semi-bonded system that allows limited movement while maintaining structural stability and drainage accuracy. * Maximum Thickness: 80 mm * Includes light reinforcing mesh to provide shrinkage relief and additional stability.

Photos now added. I need an experienced concreter to level, screed and bull float an internal slab pour. Location: Ferntree Gully VIC (rear rooms of a studio building). Details: • Approx 3.5–4.0 m³ total concrete • Two adjoining rooms at very slightly different levels (approx 100 mm height difference, brick wall between them) • Total area approx 10 m x 3.6 m • Individual spaces are 6.15m x 3.65m and 3.7m x 3.65m • 100 mm slab thickness in each space • Concrete will be wheelbarrowed (EDIT) through the building to the rear rooms by about 4 men Prep is complete: crushed rock, XPS insulation and reinforcement are all installed and ready. I need someone to handle accurate levelling, screeding and bull floating (EDIT) on this exact day - Sat 14th Feb in the morning. We estimate the pour to take about 25-35 minutes. Should only need you for about 3 hours. This needs to be someone experienced at laying and levelling concrete, and has their own tools.

Concreter to screed and expose 29m2 2.8m3 of exposed agg concrete with fall. We will move the concrete just require to screed and expose.