Find a professional tiler in Brunswick VIC

Regrout and seal/caulk 83cm x 119cm shower. Floor and walls.

Regrout a bathroom and seal. Within the shower only.

Disconnect and remove existing above bench porcelain basin. Install and silicone down new basin which is the same as the one being replaced. Install plug and washer to basin. Connect new basinto drainage and caulk. Remove all waste from site.

Grinding and tile glue removal, in preparation for sealing and polishing. 2 bedroom unit (not including bathroom/toilet areas). Floors are already fairly smooth. I don’t need the floors sealed or polished.

We need a small amount of regrouping done for our shower tiles.

We have a bathroom with 50mm drop from one corner to the other. Need the floor screeded to level it out.

Hi, looking for licensed tiler to removal of exisiting tile, prepare surface for new tiles, waterproofing and reinstalling tiles to ensuite to similar area. Rough area around 8 sqm. Tiles going to be provided. Please provide quote- time is flexible. Thank you.

Remove existing entry way tiles (1120mm x 960mm) and lay new tiles (120mm x 120mm square style).

We recently purchased an apartment which has been used as a rental property for many years and the shower is in desperate need of regrouting. Unfortunately, some of the tiles have cracked and a couple (replacement tiles - not original to the shower) are not flush against the wall. We realise the shower’s appearance can’t be revived completely but we want to be very sure it’s sealed and no water is getting in behind it for a good while before we can afford to renovate our whole bathroom! The existing grout is dry, crusty and can be peeled away in places. The outside where the shower entrance meets the floor also needs to be resealed. We would do this ourselves but are time poor with work and I have lower back issues. Please help!

Cut two porcelain tiles - I am replacing two cracked porcelain tiles and need the two new tiles cut to size. Tiles are approx. 430mm square and need approx. 20 mm cut off the edges with a wte diamond cutter for a clean straight edge

I would like to decorate my small downstairs toilet with tiles about 1m up the wall on all 4 walls. I have found the tiles I would like online but don't know how many to order and will need someone to cut them to the correct size and install. Picture of toilet and tiles attached. Link to tiles: https://www.abiinteriors.com.au/product/ravello-travertine-inverted-finger-mosaic-tile/

Ready for floor tiling on Tuesday 24th or Wednesday 25th.. The tiles are 45cm x 45cm. The floor will need a reasonable amount of screed as there are many uneven parts. I would like the tiles laid in a brick bond pattern. See photos attached - more demolition happening tomorrow… the old black tiles will be gone, as well as the bathroom vanity, and half of the brick wall will be gone too. Because the old kitchen and bathroom, as well as most walls will be completely demolished at the time of laying the floor tiles, there isn’t many areas that involve fiddly work. All tiles are already on site. No grout or screed has been purchased yet.

Remove white kitchen splashback tiles, re cut/tile/grout etc with tiles we have purchased. Involves cutting tiles along the windowsill and under range hood. Planning on extending tiles up from original height of splashback to also surround the window. New tiles we have are ceramic: https://tilecloud.com.au/products/new-newport-gloss-subway-jade-green-tile?variant=32197674729521

Balcony grouting needs to be checked, appx 6x4m space Assume 80%+ of all grouting is fine, assume caulking is fine, but want to regrout any areas which require it

Lower section of tiles in shower need re-grouting. Re-grouting needed around outside of bath. Re-grouting/caulking required around laundry trough situated in the bathroom too. The idea is to 'refresh' the look of the bathroom.

Wanting a tradesperson to remove and dispose of tile and backing board from kitchen splashback area. Area is approx 3.5 square m all up

Run down shower needs tiles and base removed, needs to be waterproofed and vinyl fit out

Our bathroom shower base needs to be regrouted. The grout needs to be stripped out properly and then epoxy grout laid. Needs to be a professional tiler. The space is small- 1 metre by 1 metre.

Remove old shower floor grout Remove old grout/silicone wall-floor joints Clean and dry joints Regrout shower floor with polymer fortified mould resistant flexgrout Install new silicone wall-floor joints Apply penetrating sealer to grout

I have wholes on my bathroom wall and like to fix to make waterproof