Find experienced local tradies in Adelaide Station Arcade

I just want a built in wardrobe for my room

I need someone to supply and install a timber batten screen to stairs with a handrail to one side. Screen to be from stringer to underside of ground floor ceiling. Preferably 50mm natural oak timber battens. Clear coat required to finish Single handrail to one side of stair to be Stainless Steel Location on south terrace side of Adelaide CBD. Open to alternatives to screen such as Stainless Steel Balustrade or metal screen

Small dent/hold in the wall, the size of a regular finger

Looking to purchase built in wardrobes from marketplace and install in my apartment in two rooms

Stainless steel balustrade sourced and installed

The exterior wall need to repair the gaps between the panels and make them flat and re render. - Due date: Flexible

I am planning to buy a retractable awning for our backyard (link below). I need installation (brick). https://www.bunnings.com.au/windoware-4-x-3m-full-cassette-folding-arm-motorised-awning_p1262180

Replace 8 old Perspex panels that are installed on inside of the balcony framework. Existing panels are each screwed on using 6 hex screws. Install vertical channels on the balcony upright frames that will enable all of the 8 Perspex panels to be easily removed by sliding up the channel. Install simple fixing so that each panel cannot be removed by children. - Due date: Flexible

2 planter boxes + 1 letterbox to be rendered and texture coated. Located in Hope Valley, 5090.

A small spot of drywall peeled off. - Due date: Needs to be done on Sunday, 23 October 2022

Hi i would like you to quote on 2 brick piers to be rendered and top coat texture

Dunlop acrylic Render has been purchased, needing someone to render some brick work (doesn’t have to be thick). About half the job will have an airconditioner unit in proximity. 5.22m2 to be precise. I have corner plastic and ladder already. No need to paint!

HI I have purchased a built in wardrobe just need someone to install.

4 x shelves hung into brick masonry and normal gyprock. 1 x toilet roll holder installed into tiles large. 1 x timber table sawed back in length by approximately 2cm. 1 x light fitting patched up and painted (where the old smoke detector was). - Due date: Flexible

External wall 4x2 m . 5 years old. Render surface bubbling with cold weather and delaminating in places, ?patch repair

80cm by 20cm no pain require just reinstall drywall

Hi, Please I want a quote for renovating an internal built in wardrobe Round dimensions are as follows: Height: 270 cm Width: 80 cm Depth: 60 cm If I need half of the lower bit drawers (4-5) with ordinary door ( Milamine) Also how much extra cost if I want the outer doors to be laminated?

I have a misting kit, fairy lights snd magnetic hooks that need to be put up on the veranda at the back.